RAM Mount VBD-122-SW1 User Manual

Item Number
RAM-VBD-122
UNIVERSAL (ALL VEHICLES)
SPECIFICATIONS
Placement
Flat surface/floor
Drilling Required
Yes
RAM Drill Seat Bases
National Products, Inc.
Seat Configuration
Bucket/Bench
Construction/Finish
Steel/Black Powdercoat
Dimensions
A = 8", B = 8", C = 18.25"
Pole or Pedestal
Included
Weight
6.9 lbs.
Features
Universal base for any vehicle with a flat mounting surface
Misc.
Rugged Steel Construction
Lifetime warranty
Shown In Use
RAM-VBD-122
National Products, Inc. Phone: 206-763-8361 Fax: 206-763-9615 Address: 1205 S Orr St Seattle, WA 98108 Website: www.ram-mount.com Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VBD-122
RAM Drill Seat Bases
National Products, Inc.
UNIVERSAL (ALL VEHICLES)
INSTALLATION INSTRUCTIONS
1. Place base on floor so that the pedestal is in the optimum location.
2. Mark the mounting hole locations. Please note that it might be necessary to shim a corner of the mounting base if the floor surface is uneven.
3. Drill 17/32” holes in the floor at all of the marked locations. Be extremely careful not to damage any equipment under the floor board of the vehicle when drilling.
4. Tighten base in place using bolts, washers, and nuts. If floor is less than 1/4” thick, please use fender washers on the underside to help distribute the weight.
National Products, Inc. Phone: 206-763-8361 Fax: 206-763-9615 Address: 1205 S Orr St Seattle, WA 98108 Website: www.ram-mount.com Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...