RAM Mount VBD-101-SW1 User Manual
Item Number
RAM-VBD-101
Vehicle base for the
CHEVROLET SILVERADO (1999-2006)
CHEVROLET SUBURBAN (2000-2006)
CHEVROLET TAHOE (2000-2006)
DODGE DURANGO (2004-NEWER)
FORD EXCURSION (2000-2005)
FORD F-150 (1997-NEWER)
FORD F-250 LIGHT DUTY (1997-2004)
FORD F-250, F-350, F-450, F-550, F-750 SUPER DUTY TRUCKS (1999-NEWER)
FORD RANGER (1993-NEWER)
GMC YUKON (2000-2006)
SPECIFICATIONS
Placement
Flat surface/floor
Drilling Required
Yes
Pole or Pedestal
Seat Configuration
Bucket/Bench
Construction/Finish
Steel/Black Powdercoat
Additionally purchased
Weight
6.4 lbs.
RAM Drill Seat Bases
National Products, Inc.
Shown In Use
Dimensions
A = 20.25", B = 5.25", C = 5.5", D= 4”
Hole Center = 6.63”
Features
Universal base for any vehicle with a flat mounting surface
Misc.
Rugged Steel Construction
Lifetime warranty
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: staff@ram-mount.com
RAM-VBD-101
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VBD-101
RAM Drill Seat Bases
National Products, Inc.
Vehicle base for the
CHEVROLET SILVERADO (1999-2006)
CHEVROLET SUBURBAN (2000-2006)
CHEVROLET TAHOE (2000-2006)
DODGE DURANGO (2004-NEWER)
FORD EXCURSION (2000-2005)
FORD F-150 (1997-NEWER)
FORD F-250 LIGHT DUTY (1997-2004)
FORD F-250, F-350, F-450, F-550, F-750 SUPER DUTY TRUCKS (1999-NEWER)
FORD RANGER (1993-NEWER)
GMC YUKON (2000-2006)
INSTALLATION INSTRUCTIONS
1. Place base on floor so that the pedestal is in the optimum location.
2. Mark the mounting hole locations. Please note that it might be necessary to shim a corner of the mounting base if
the floor surface is uneven.
3. Drill 17/32” holes in the floor at all of the marked locations. Be extremely careful not to damage any equipment
under the floor board of the vehicle when drilling.
4. Tighten base in place using bolts, washers, and nuts. If floor is less than 1/4” thick, please use fender washers on
the underside to help distribute the weight.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...