RAM Mount VB-173-SW1 User Manual

Item Number
RAM-VB-173 & RAM-VB-173-SW1
PONTIAC VIBE (2009) SCION XB (2008-2011) TOYOTA COROLLA (2010) TOYOTA MATRIX (2009) TOYOTA PRIUS (2010-2013)
SPECIFICATIONS
Placement
Passenger side on the floor, under front seat
Drilling Required
No - uses existing seat bolts
RAM No-Drill TM Seat Bases
National Products, Inc.
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
A = 18.125", B = 9.375", C = 1.375” Hole Centers = 14.312”
Pole or Pedestal
Sold Separately
Weight
6 lbs.
Features
Installs in minutes with no drilling required Low profile keeps mount away from passenger leg space
Misc.
Rock solid construction Lifetime warranty
RAM-VB-173-SW1
RAM-VB-173
National Products, Inc. Phone: 206-763-8361 Fax: 206-763-9615 Address: 1205 S Orr St Seattle, WA 98108 Website: www.ram-mount.com Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VB-173 & RAM-VB-173-SW1
RAM No-Drill TM Seat Bases
National Products, Inc.
PONTIAC VIBE (2009) SCION XB (2008-2011) TOYOTA COROLLA (2010) TOYOTA MATRIX (2009) TOYOTA PRIUS (2010-2013)
INSTALLATION INSTRUCTIONS
1. Move the passenger seat back to its rearmost position and remove the front seat rail bolts on the passenger side. This will require a 14mm socket wrench. If installing into a 2010 Corolla or Prius, you will need the two short sections of pipe, stand-offs, and the longer seat leg bolts. See notes below then proceed with remaining instructions.
2. Without moving the seat, place the No-Drill™ base over the front of the seat frame legs.
3. Align the holes in the base with those of the seat frame legs. The pedestal platform should be near the console.
4. Re-install the seat bolts and fully tighten.
For 2010 Corolla or Prius, place the stand offs over the seat leg holes. Next rest the base over the stand offs and align the holes through to the floor board. Start the thread of the supplied bolts into the floor board by hand. Once they are started, use a 17mm socket to tighten. Tighten the center bolt first, then the bolt closest to the door. The bolt closest to the door may require the use of a 17mm box end wrench to fully tighten the bolt for clearance reasons. The base may touch the center hump of the vehicle and the carpeting in some vehicles due to variations in the carpeting.
National Products, Inc. Phone: 206-763-8361 Fax: 206-763-9615 Address: 1205 S Orr St Seattle, WA 98108 Website: www.ram-mount.com Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.