RAM Mount VB-165-SW1 User Manual

Item Number

RAM-VB-165

Vehicle base for the

HUMMER H3 (2006-2009)

SPECIFICATIONS

Placement

Passenger side, in front, where seat frame meets
floor board.

Drilling Required

None - uses existing seat bolts

RAM No-Drill TM Seat Bases

National Products, Inc.

Seat Configuration

Bucket

Construction/Finish

Steel/Black Powdercoat

Dimensions

A = 16.125", B = 6.875", C = 3.25"
Hole Center = 11.8125”

Pole or Pedestal

Ordered Separately

Weight

4.3 lbs.

Features

Installs in minutes with no drilling required

Misc.

Rock solid construction
Lifetime warranty

Shown In Use

RAM-VB-165

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Item Number

RAM-VB-165

RAM No-Drill TM Seat Bases

National Products, Inc.

Vehicle base for the

HUMMER H3 (2006-2009)

INSTALLATION INSTRUCTIONS

Tools suggested for this installation are an 18MM socket wrench.

1. Using a socket wrench, remove the two seat rail bolts that hold the seat frame to the floor board. These are
located at the bottom front of the passenger seat.

2. Once the seat bolts are removed, set them aside.

3. Place the No-Drill™ base with the mounting platform closest to the center hump.

4. Align the holes in the No-Drill™ base with those in the floor board.

5. Pass the factory seat rail bolts through the No-Drill™ base and partially re-thread them into the floor board by hand.

6. Once both bolts have been started by hand, use the socket wrench to re-tighten.

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.