RAM Mount VB-164-SW1 User Manual

Item Number

RAM-VB-164

RAM No-Drill TM Seat Bases

National Products, Inc.

Vehicle base for the

SEARS SEATING ATLAS SERIES SEATS (2005-NEWER)

SPECIFICATIONS

Placement

Attaches to upper section, left hand side of
passenger seat. Base is designed to match
contours and align with existing hole
patterns for ease of installation.

Drilling Required

No - uses existing seat bolts

Seat Configuration

Bucket

Construction/Finish

Steel/Black Powdercoat

Dimensions

A = 18.25", B = 7.50", C = 11"
Hole Center = 13.75”

Pole or Pedestal

Included on Base

Weight

6.9 lbs.

Features

Installs in minutes with no drilling required

Misc.

Rock solid construction

Lifetime warranty

Shown In Use

RAM-VB-164

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Item Number

RAM-VB-164

RAM No-Drill TM Seat Bases

National Products, Inc.

Vehicle base for the

SEARS SEATING ATLAS SERIES SEATS (2005-NEWER)

INSTALLATION INSTRUCTIONS

Tools suggested for this installation are ½” box end wrench or socket wrench.

1. Detach the seat frame skirt from the front and left side of the passenger seat.

2. Locate the two bolts that pass through the “u” shaped seat track into the frame at the front and back.

3. Using a ½” wrench, remove the nut that holds the seat track to the upper part of the seat frame. Set the nuts
aside. HINT: Using a small screw driver to wedge the bolt inside the seat track may keep it from falling out of place
during installation.

4. Carefully raise the seat up so that the seat track is above the seat frame with the two track bolts hanging down.
You only need to raise the seat enough to pass the no drill base in between.

5. Place the No-Drill TM base in between the seat track and seat frame with the mounting holes aligned with the
two bolts hanging down.

6. Slowly lower the seat so that the bolts pass through the holes in both the No-Drill TM base and the seat frame.

7. Re-install the nuts previously removed and tighten.

8. Using the provided nut and bolt, further secure the No-Drill TM base by passing the bolt though the hole on the
vertical surface of the no drill base. This is located near the center of the base and aligns with a hole in the factory seat
frame. Tighten the nut.

9. Re-install the seat frame skirt.

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.