RAM Mount VB-145-SW1 User Manual
Item Number
RAM No-Drill TM Seat Bases
RAM-VB-145 & RAM-VB-145-SW1
COMPATIBLE VEHICLES:
CHRYSLER 300 (2005-2008)
DODGE CHARGER (NON-POLICE CAR) (2006-2010)
DODGE MAGNUM (NON-POLICE CAR) (2006-2010)
SPECIFICATIONS
Placement
Passenger side, front, where seat rail frame
attaches to floor board.
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
National Products, Inc.
Dimensions
A = 18.75", B = 4.25", C = 6.875”
Hole Centers = 16.5”
Pole or Pedestal
Sold Separately
Weight
7 lbs.
Features
Installs in minutes with no drilling required
Low profile keeps mount away from passenger leg space
Important Note
In 2006 model year vehicles, the seat leg bolts are tied to the air bag
system. Tampering with these may result in disabling the air bag system
and causing a severe safety hazard. The installation of this product into a
2006 vehicle should only be done by a Chrysler factory authorized
technician or Up-fitter familiar with Police, Fire, and Rescue vehicles and
their fleet use.
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
Complete Vehicle Mount
RAM-VB-145-SW1
Vehicle Base
RAM-VB-145
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VB-145 & RAM-VB-145-SW1
RAM No-Drill TM Seat Bases
National Products, Inc.
COMPATIBLE VEHICLES:
CHRYSLER 300 (2005-2008)
DODGE CHARGER (NON-POLICE CAR) (2006-2010)
DODGE MAGNUM (NON-POLICE CAR) (2006-2010)
INSTALLATION INSTRUCTIONS
1. Move the passenger seat back to its rearmost position and remove the front seat rail bolts. Store these bolts.
2. Place the supplied stand offs over the holes in the seat frame legs and rest the No-Drill™ base on top of these.
3. Align the holes in the base, stand offs, and seat frame legs with those in the floor board. The pedestal platform
should be near the console.
4. Pass the supplied longer bolts through to the holes in the floor board and start the thread by hand.
5. Using a socket wrench, fully tighten the bolts to secure the no drill base into the vehicle.
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...