RAM Mount VB-145P-SW1 User Manual
Item Number
RAM No-Drill TM Seat Bases
RAM-VB-145P & RAM-VB-145P-SW1
COMPATIBLE VEHICLES:
DODGE CHARGER POLICE VEHICLES (2006-2010)
DODGE MAGNUM POLICE VEHICLES (2006-2011)
SPECIFICATIONS
Placement
Passenger side, front, where seat rail frame attaches to
floor board.
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
National Products, Inc.
Dimensions
A = 18.75", B = 4.25", C = 2.875”, Hole Centers = 16.5”
Pole or Pedestal
Sold Separately
Weight
7 lbs.
Features
Installs in minutes with no drilling required
Low profile keeps mount away from passenger leg space
Important Note
In 2006 model year vehicles, the seat leg bolts are tied to the air bag
system. Tampering with these may result in disabling the air bag system
and causing a severe safety hazard. The installation of this product into a
2006 vehicle should only be done by a Dodge factory authorized
technician or Up-fitter familiar with Police, Fire, and Rescue vehicles and
their fleet use.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: staff@ram-mount.com
RAM-VB-145P-SW1
RAM-VB-145P
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM No-Drill TM Seat Bases
National Products, Inc.
DODGE CHARGER POLICE VEHICLES (2006-2010)
DODGE MAGNUM POLICE VEHICLES (2006-2011)
INSTALLATION INSTRUCTIONS
1. Move the passenger seat back to its rearmost position and remove the front seat rail bolts. Store these bolts.
2. Place the supplied stand offs over the holes in the seat frame legs and rest the no drill base on top of these.
3. Align the holes in the base, stand offs, and seat frame legs with those in the floor board. The pedestal platform
should be near the console.
4. Pass the supplied longer bolts through to the holes in the floor board and start the thread by hand.
5. Using a socket wrench, fully tighten the bolts to secure the No-Drill™ base into the vehicle.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...