RAM Mount VB-138ST1-SW1 User Manual
Item Number
RAM No-Drill TM Seat Bases
RAM-VB-138ST1 & RAM-VB-138ST1-SW1
Vehicle base for the
TOYOTA FJ CRUISER (2006-2013)
SPECIFICATIONS
Placement
Passenger side on the floor, under front seat
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
A = 17.125", B = 6.5", C = 5”
Hole Centers = 15.875”
National Products, Inc.
Pole or Pedestal
Sold Separately
Weight
7.0 lbs.
Features
Installs in minutes with no drilling required
Low profile keeps mount away from passenger leg space
Notes
The RAM-VB-138ST1 will not fit BENCH SEAT MODEL TRUCKS
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
Complete Vehicle Mount
RAM-VB-138ST1-SW1
Vehicle Base
RAM-VB-138ST1
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VB-138ST1 & RAM-VB-138ST1-SW1
RAM No-Drill TM Seat Bases
National Products, Inc.
Vehicle base for the
TOYOTA FJ CRUISER (2006-2013)
INSTALLATION INSTRUCTIONS
1. Attaching the fixed Adjust-A-Pole™ to the No-Drill™ base should be done prior to attaching the base to
the vehicle. For a finished look, assemble so the rounded heads of the carriage bolts are on top.
2. Move the passenger seat back to its rearmost position and remove the front seat rail bolts using a 14mm
socket wrench. Save and store these bolts should the mount be later removed.
3. Using the provided hardware, place the washers over the longer bolts, pass the bolts through the No Drill™ base, next through the round stand-offs, and align over the threaded holes in the floor board.
4. Start bolts by hand to insure that the bolts do not cross thread
5. Using a 17mm socket wrench, fully tighten the bolts to secure the base.
6. After a day of use, re-tighten the seat bolts holding the mount.
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...