RAM Mount VB-137ST1-SW1 User Manual

Item Number

RAM-VB-137ST1

Vehicle base for the

TOYOTA TUNDRA (2000-2006)

SPECIFICATIONS

Placement

Passenger side on the floor, under front seat

Drilling Required

No - uses existing seat bolts

RAM No-Drill TM Seat Bases

National Products, Inc.

Seat Configuration

Bucket

Construction/Finish

Steel/Black Powdercoat

Dimensions

A = 18.125", B = 9.375", C = 5.375”
Hole Centers = 17”

Pole or Pedestal

Sold Separately

Weight

9.6 lbs.

Features

Installs in minutes with no drilling required
Low profile keeps mount away from passenger leg space

Misc.

Rock solid construction
Lifetime warranty

* Note that this base is best used for bucket seats.

Shown with optional riser

RAM-VB-137ST1

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Item Number

RAM-VB-137ST1

RAM No-Drill TM Seat Bases

National Products, Inc.

Vehicle base for the

TOYOTA TUNDRA (2000-2006)

INSTALLATION INSTRUCTIONS

1. If using a riser, it should be attached to the No-Drill™ base prior to attaching the base to the vehicle. For a finished
look, assemble so the rounded heads of the carriage bolts are on top. A riser is not necessary for most applications.

2. Move the passenger seat back to its rearmost position and remove the front seat rail bolts using a 14mm socket
wrench. Save and store these bolts should the mount be later removed.

3. Using the provided hardware, place the washers over the longer bolts, pass the bolts through the No-Drill™ base,
next through the round stand-offs, and align over the threaded holes in the floor board.

4. Start bolts by hand to insure that the bolts do not cross thread

5. Using a 17mm socket wrench, fully tighten the bolts to secure the base.

6. After a day of use, re-tighten the seat bolts holding the mount in place.

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.