RAM Mount VB-116-SW1 User Manual
Item Number
RAM No-Drill TM Seat Bases
RAM-VB-116 & RAM-VB-116-SW1
Vehicle base for the
CHEVROLET COLORADO (2004-2012)
GMC CANYON (2004-2012)
SPECIFICATIONS
Placement
Passenger side on the floor, in front of seat
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket/Bench
Construction/Finish
Steel/Black Powdercoat
Pole or Pedestal
Ordered Separately
Weight
10.7 lbs.
Dimensions
A = 14", B = 4.75", C = 5.5", D = 17”
Hole Center = 11.75”
Tools required for base installation
18mm box end wrench, 18mm socket, universal joint adaptor or
wobble, and socket wrench for base installation. Tools for complete
system assembly: pliers, phillips screw driver, #10, ½”, 9/16” box
end wrench’s.
National Products, Inc.
Complete Vehicle Mount
RAM-VB-116-SW1
D
C
Features
Installs in minutes with no drilling required
Angled step moves pole away from passenger leg space
Won’t interfere with levers or factory-installed console or 4WD lever
Important Note
The RAM-VB-116 base will not fit crew cab vehicles where the
vent duct passes under the front of the passenger seat. Consider
attaching the riser to the no drill base prior to vehicle installation.
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
B
RAM-VB-116, SHOWN WITH
RAM-VB-SB4 RISER (INCLUDED)
A
Item Number
RAM-VB-116 & RAM-VB-116-SW1
RAM No-Drill TM Seat Bases
National Products, Inc.
Vehicle base for the
CHEVROLET COLORADO (2004-2012)
GMC CANYON (2004-2012)
INSTALLATION INSTRUCTIONS
Tools required for installation are an 18mm socket, and ½” box end wrench. You may also consider using a wobble
adapter or universal joint style extension to aid in the installation of the hump side seat leg bolt.
1. Attach the adjustable riser to base with the provided carriage bolts, washers, and nuts. Use the ½” box end wrench
to fully tighten the riser to the base.
2. Move the passenger seat to the rearmost setting.
3. Remove the front seat rail bolts that fasten the passenger seat brackets to the vehicle floor using the 18mm socket.
4. Pass the bolts you just removed through the holes in the No-Drill™ base.
5. Place the base with bolts over the seat frame legs, align the bolts with the holes, and start the thread by hand into
the vehicle floor board.
6. Once both bolts have been started by hand, use the 18mm tools and fully tighten to 35 ft lbs.
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...