RAM Mount VB-101-SW1 User Manual

Item Number

RAM No-Drill TM Seat Bases

RAM-VB-101 & RAM-VB-101-SW1

Vehicle base for the

CHEVROLET S-10 4x4 only (1995-2004)
CHEVROLET S-10 BLAZER (1995-2001)
GMC JIMMY (1995-2001)
GMC SONOMA (1995-2004)

SPECIFICATIONS

Placement

Passenger side floor board, in front of seat
Between seat frame and floor board

National Products, Inc.

Drilling Required

None - uses existing seat bolts

Seat Configuration

Bucket/Bench

Construction/Finish

Steel/Black Powdercoat

Dimensions

A = 16”, B = 6.75", C = 3.75", D = 7.75”

Hole Center = 13.13”

Pole or Pedestal

Sold Separately

Weight

10.7 lbs.

Features

One 4” riser is included with this vehicle base. Riser allows
optimized placement of mount with a minimal amount of
intrusion of passenger leg space.

Complete Vehicle Mount

RAM-VB-101-SW1

RAM-VB-101, SHOWN WITH

RAM-VB-SB4 RISER (INCLUDED)

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Item Number

RAM-VB-101 & RAM-VB-101-SW1

RAM No-Drill TM Seat Bases

National Products, Inc.

Vehicle base for the

CHEVROLET S-10 4x4 only (1995-2004)
CHEVROLET S-10 BLAZER (1995-2001)
GMC JIMMY (1995-2001)
GMC SONOMA (1995-2004)

INSTALLATION INSTRUCTIONS

1. Attach the RAM-VB-SB4 riser with 5/16” carriage bolts, flat washer, lock washers, and nuts.

2. Remove the two front seat bolts that connect the passenger seat to the floor. These may be under plastic caps.

3. Tilt the front of the passenger seat upward to clear the studs and slide the No-Drill™ base under the seat until the
slots in the base line up with the seat bolt studs.

4. Lower the seat back down into position.

5. Install the two front seat nuts and fully tighten.

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.