RAM Mount Powered Dock for Unitech User Manual

RAM™ POWERED DOCK FOR UNITECH™ PA690: USER GUIDE

SECURING DC CABLE TO RAM™ POWERED DOCK

TO ATTACH POWER CABLE, REMOVE DC COVER FROM BOTTOM DOCKING CUP USING PHILLIPS SCREWDRIVER. PLUG 90-DEGREE POWER CABLE INTO DC PORT. REPOSITION DC COVER OVER THE 90-DEGREE POWER CABLE AND TIGHTEN UNTIL COVER IS SECURE. DO NOT OVER-TIGHTEN.

JUMPER SELECTION

OPTION 1 (FOR MOST CASES):

*FACTORY SETTING

PIN 1 - CONNECTED NORMALLY IN RS232 AS DCD PIN 1 - NO 5V POWER PIN 9 - CONNECTED NORMALLY IN RS232 AS RI PIN 9 - NO 5V POWER

OPTION 2: PIN 1 - DISCONNECTED FROM RS232 CIRCUITRY PIN 1 - WITH 5V POWER SUPPLY PIN 9 - KEEP CONNECTED IN RS232 CIRCUITRY AS RI PIN 9 - NO 5V POWER

DOCKING INSTRUCTIONS

1. PLACE TOP END OF DEVICE INTO TOP CUP. ENGAGE SPRING TENSION BY APPLYING UPWARD FORCE.

2. ONCE UPWARD FORCE IS APPLIED, THERE SHOULD BE ROOM TO FIT ENTIRE DEVICE INTO DOCKING STATION WITHOUT MAKING CONTACT WITH BOTTOM CUP. ALIGN BOTTOM OF DEVICE WITH GROOVES IN DOCKING CUP.

USB/RS232 HOST SELECTION

USB Host Position

RS 232 Host Position

OPTION 3: PIN 1 - KEEP CONNECTED IN RS232 CIRCUITRY AS DCD PIN 1 - NO 5V POWER PIN 9 - DISCONNECTED FROM RS232 CIRCUITRY PIN 9 - 5V POWER SUPPLY

3. ONCE ALIGNED, ALLOW SPRING TENSION TO ENGAGE YOUR DEVICE WITH DOCKING CONNECTOR PINS ON DOCKING CUP.

FACTORY

SETTING

National Products, Inc., 8410 Dallas Ave S., Seattle, WA 98108, (206) 763-8361 www.rammount.com

RMR-INS-HOL-UNI2P