KEY FOB
PARKSENSE
KEY FOB FEATURES
Key Fob
1 — Cargo Doors
2 — Unlock
3 — Lock
Locking And Unlocking The Doors
• Push the lock button once to lock all the
doors.
• Push the unlock button once to unlock both
the driver and passenger doors.
• To lock or unlock the cargo area doors, push
the cargo area door lock switch located on
the driver door trim panel.
For further information, and applicable warnings
and cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Canadian Residents).
Parksense Rear Park Assist
If an object is detected behind the rear bumper
while the vehicle is in REVERSE, a chime will
sound. The chime rate will change depending
on the distance of the object from the rear
bumper, getting faster as the object approaches. The chime will sound continuously
when the distance between the vehicle and the
detected object is less than 12 inches (30 cm).
Parkview Rear Back-Up Camera
You can see an on-screen image of the rear of
your vehicle whenever the gear selector is put
into REVERSE. The ParkView Rear Back-Up
Camera image appears on the display screen
located on the center stack of the instrument
panel.
NOTE:
If the display screen appears foggy, clean the
camera lens located on the top rear of the
vehicle below the center light.
SEATS
For further information, and applicable warnings and cautions, please refer to the Owner’s
Manual at www.mopar.com/en-us/care/ownersmanual.html (U.S. Residents) or
www.owners.mopar.ca (Canadian Residents).
Seat Features
Forward And Rearward Adjustment
The adjusting bar is at the front of the seat, near
the floor. Pull the bar upward to move the seat
forward or rearward. Release the bar once the
seat is in the desired position. Then, using body
pressure, move forward and rearward on the
seat to be sure that the seat adjusters have
latched.
Driver’s Seat
1 — Forward/Rearward Adjustment Bar
2 — Front Height Adjusting Lever
3 — Rear Height Adjusting Lever
4 — Recliner Adjusting Knob
5 — Lumbar Adjustment Knob
Lumbar Support — If Equipped
This feature allows you to increase or decrease
the amount of lumbar support. The lumbar
control knob is located on the rear upper outboard side of the driver's seatback. Rotate the
control forward to increase and rearward to
decrease the desired amount of lumbar support.
Height Adjustment (Without Swivel Seat) — If
Equipped
The height adjusting levers are located on the
center outboard side of the seat. Lift the front
lever with little or no weight applied to the seat,
to raise the front on the seat. Lift the front lever
with weight applied to the seat to lower it.
Follow these instructions for the rear lever to
adjust the rear of the seat.
Height Adjustment (With Swivel Seat) — If
Equipped
The height adjusting knobs are located on the
center outboard side of the seat. Rotate the
front knob to adjust the front of the seat up or
down. Rotate the rear knob to adjust the rear of
the seat up or down.
Recliner Adjustment
The recliner knob is on the rear outboard side of
the seat. To recline the seatback, lean back,
rotate the knob rearward to position the seatback as desired. To return the seatback to its
normal upright position, lean forward, rotate
the knob forward until the seatback is in the
upright position.
Heated Seats — If Equipped
Heated Seat Switch
On some models, the front driver and passenger
seats may be equipped with heaters in both the
seat cushions and seatbacks. The controls for
the front heated seats are located on the lower
outboard side of the seat.
To Turn Heated Seats On/Off
1. Push the switch once to turn on the heated
seats.
2. Push the switch a second time to shut the
heating elements off.
MIRRORS
Adjustable Armrests — If
Equipped
Adjuster Wheel
The seat adjustable armrest can be raised and
adjusted for height. Underneath the front of the
armrest is the adjuster wheel which will adjust
the height of the armrest up or down.
Turn the adjuster wheel to the right or left to
adjust the height of the armrest up or down.
Power Folding Mirrors — If
Equipped
The switch for the power folding mirrors is
located on the driver’s door panel below the
power mirror controls. The power fold mirrors
are designed to be folded and unfolded using
the power folding switch.
Operation
• Push the switch to the right and the mirrors
will fold in.
• Push the switch to the left and the mirrors
will return to the normal driving position.
To Reset The Power Folding Mirror
1. Push the switch to the right and the mirrors
will fold in to the closed position.
2. Push the switch to the left and the mirrors
will return to the open position.
NOTE:
The intended use of the power fold mirrors is by
pushing the buttons to fold and unfold the
mirrors. Only manually fold the mirrors when
necessary.
Forward Folding
Mirrors can be folded forward manually or by
accidental impact. In this case, it is possible to
restore to position both ways, manually and
electrically.