Rally Armor Mitsubishi EVO 8, IX, MR User Manual

EVO 8/IX/MR+

Mud Flap Instructions

Please see Web site for a better view of the photos.
Rally Armor recommends professional installation.

Rally Armor EVO mud flap set includes 2 rears and 2 fronts (“L” shaped)
Your mounting hardware consists of:
6 Clips (PolCl)
10 Washers (FenWash)
6 Short Stainless Screws (1SS)
4 Long Stainless Screws (2SS)
2 Spacers (1SP)

In order to complete this install for the rear mud flaps, you will remove the tires. The fronts can be
completed by turning the steering wheel away from the side you are working on but removal of tires will
facilitate installation.

Note: Once the clips are placed over the front wheel wells, the flaps can be removed and bolted back on at

will without having to remove the front tires.

FRONT MUD FLAP installation:
Step 1: Remove front wheel jack car up and place on sturdy jack stands. You may also install with the tires

on and turned.

Step 2: Remove clips A – C then Unbolt D (fig. A).
Step 3: Remove two front screws from side skirt in order to pull away (E) (fig. A/B).

A) B)

Step 4: Pull the side skirt down slightly and remove the liner slowly.

Cautionary Note: The liner tears easily so be careful and work slowly away from the clips.

C) D)

Step 5: Place 3 clips over A, B, and C (note "B" is behind the side skirt).
Step 6: Replace liner as it was before (covering the clips) Bolt the 10mm wheel liner bolt back (D). Refer to

the other side of the car if you need to recall how it is put back together. Carefully replace the liner as it was
before the install to avoid rubbing.
Step 7: Bolt the mud flap as follows (note the long bolt on the side skirt bolt). Install the two side skirt
screws as well.

E) F)

Rear Flaps

Step 1: Begin by removing the rear wheel and placing the car on jack stands (fig. G) - if you can jack

up the car enough to reach the inner bolt you may also choose to install without removing the tires.
Step 2: Remove the two rear bolts that hold the liner then prepare a long screw with a washer (fig. I).