Rally Armor 2015+ Subaru Outback User Manual

IMF 34/36

YOUR MOUNTING HARDWARE CONSISTS OF:

Quantity

Hardware Item

Item ID

2

Rear Brackets

HMF14/16-BR-RE

2

Short Spacers

.25sp

2

White Inserts

Ins7 6 Flat Clips

UClip

6

Polygon “Poly” Edge Clips

PolCl

10

Stainless Steel Screws

1.5SS

4

Stainless Steel Screws

1SS

14

Washers

SmWash

SCREW GUIDE

FASTENER GUIDE

CAUTIONARY TIP: The hardware is strong and self-threading but over-tightening the mounting clips is not advised.
INSTALLATION TIP: To ease installation and avoid damage to existing OEM clips during removal, a well-lit, climate controlled installation environment is recommended.
TO THE INSTALLER: Please return these instructions to the customer after installation. Always test and check wheel clearances before returning vehicle.
TO THE CUSTOMER: Retain these instructions after installation. They may be necessary for installing other optional parts or removal of this accessory.

2015+ SUBARU LEGACY AND OUTBACK MUD FLAP INSTALLATION INSTRUCTIONS

PLEASE REVIEW THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING INSTALLATION

For high resolution color images of these instructions, please visit http://www.rallyarmor.com

To protect your Rally Armor mud flaps, care must be taken during parking and reversing. Rally Armor always recommends professional installation.

Check wheel clearances after installation, especially on vehicles outfitted with non-OEM offset wheels and suspensions. Adjust accordingly.

Rally Armor is not responsible for damage or loss of installed mud flaps.

Each mud flap set contains 4 flaps, mounting hardware and brackets (unless otherwise noted).
Recommended tools: Philips Screwdriver, small & long flat head screwdrivers.

Version 1.0 Release Date 10.27.2014 1

IMF 34/36

Front Mud Flap Installation

• (Figure A) Begin by parking the vehicle on an even surface. Turn the steering wheel as to allow access to the inner wheel well area.
Remove the 4 OEM fender liner fasteners. Pull liner away to gain access to the interior fender area.

• (Figure B) Place 2 “Poly” edge clips (PolCl) over the two upper mounting tabs (as shown). Place “Flat” U clip (UClip) over the inner
side skirt mounting hole. Replace liner over the mounting points. Replace original fastener underneath.

• (Figure C) Place the mud flap with the logo facing the rear of the vehicle, against the corresponding mounting points on the fender
liner. Place a washer (SmWash) over a screw (1.5SS) through the flap into the each of the mounted clips. Important: For the lower
inner mounting point, place a small spacer (.25sp) behind the mud flap. Align outer edge of the flap by incrementally adjusting the
angle of the flap and bracket and walking away from the vehicle until the flap is perpendicular to even ground. Tighten all mounting
screws and bracket bolt only until snug and flush with the surface of the mud flap. Do not over tighten the mounting points.

Rear Mud Flap Installation

• (Figure D) Place a “Flat” U clip (UClip) over each of the two outer bumper mounting points as shown.

• (Figure E -Legacy) Remove fastener underneath bumper cover. Place INS7 (white insert in the wheel well liner mounting point. Slide

wheel well liner back into the bumper. Ensure insert is visible in liner through the mounting point in the bumper skin.

• (Figure F- Outback) Example of Figure (F).

Version 1.0 Release Date 10.27.2014 2