Rally Armor 2014+ Mazda 3 User Manual

IMF31

YOUR MOUNTING HARDWARE CONSISTS OF:

GUIDE TO SCREWS PROVIDED:

HOW TO REMOVE STOCK FASTENERS:

Quantity

Hardware Item

Item ID

10

Flat U Clips

UClip

12

Small Washers

SmWash 2 Lock Nuts

SSLnut

2

Short Screws

.75SS

8

Standard Screws

1SS

2

Inserts

Ins3

2

Front Mounting Brackets

HMF31-FR-BR

2

Rear Mounting Brackets

HMF14/16-R-BR

Recommended tools: Offset, ratcheting or stubby Phillips screwdriver, small flat head screwdriver, drill and bit
assortment, 7/16” wrench, marker.

Cautionary Tip: The hardware is strong and self-threading but over-tightening the clips is not advised.

Installation Tip: To ease installation and avoid damage to existing OEM clips during removal, a well-lit, climate

controlled installation environment is recommended.

Parking and Reversing: Any extended mud flap application can be damaged or dislodged should they get caught in
between a tire and a curb or object. To protect your Rally Armor mud flap set, care must be taken during parking and
reversing.

To the customer: Retain these
instructions after installation. They may
be necessary for installing other optional
parts or removal of this accessory.

To the installer: Please return these
instructions to the customer after
installation. Always test and check wheel
clearance before returning vehicle

2014+ MAZDA3 MUD FLAP INSTALLATION INSTRUCTIONS

For high resolution color images of these instructions, please visit http://www.rallyarmor.com

Check wheel clearance after installation, especially vehicles outfitted with non-OEM wheels and suspensions.

To protect your Rally Armor mud flap set, care must be taken during parking and reversing.

Rally Armor is not responsible for damage or loss of installed flaps.

IMF 31 Version 1.1 1

IMF31

Front Mud Flap Installation

• (Figure A) Park vehicle on an even surface. Turn the steering wheel towards the side you are working on. Remove 3 outer fender
liner fasteners.

• (Figure B) Pull liner away to gain access to inner fender. Place a Flat U clip (UClip) over each of the 2 lower mounting points as
shown.

• (Figure C) Replace liner as before, and re-install upper mounting fastener.

• (Figure D) Place the front bracket against the logo side of the flap, with upper stud through the top mounting hole. Bracket and

flap assembly will align with the outer edge of the wheel well liner.

• (Figure E) Position the front mud flap with logo facing the rear of the vehicle with the bracket between flap and the outer edge of
the liner. Using a standard screw (1SS) and a washer (SmWash), loosely bolt through the mud flap and into each of the two
mounting points where the UClips have been installed. Carefully place a Locknut (SSLnut) with washer (SmWash), over the top
mounting point, and secure the lower inside mounting point with the supplied insert (Ins3).

• (Figure F) Align outer edge of the flap by incrementally adjusting the assembly side to side, as well as the lower & upper portions
of the flap. Check your adjustment, and confirming the flap is perpendicular to even ground. Tighten all mounting screws and nuts
only until snug against washer. Do not over tighten the mounting screws or cross-thread the locknut.

Rear Mud Flap Installation

IMF 31 Version 1.1 2