
IMF 26
YOUR MOUNTING HARDWARE CONSISTS OF:
Stainless Steel Lock Nuts
Short Stainless Steel Screws
1SS 6 Long Stainless Steel Screws
2SS 2 Plastic Hex Bolt Inserts
Cautionary Tip: The hardware is strong and self threading but over-tightening the mounting clips is not advised.
Installation Tip: To ease installation and avoid damage to existing OEM clips during removal, a well lit, climate controlled installation environment is recommended.
To the installer: Please return these instructions to the customer after installation. Always test and check wheel clearances before returning vehicle.
To the customer: Retain these instructions after installation. They may be necessary for installing other optional parts or removal of this accessory.
2013+ SUBARU IMPREZA XV CROSSTREK MUD FLAP INSTALLATION INSTRUCTIONS
PLEASE REVIEW THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING INSTALLATION
For high resolution color images of these instructions, please visit http://www.rallyarmor.com
To protect your Rally Armor mud flaps, care must be taken during parking and reversing. Rally Armor always recommends professional installation.
Check wheel clearances after installation, especially on vehicles outfitted with non-OEM offset wheels and suspensions. Adjust accordingly.
Rally Armor is not responsible for damage or loss of installed mud flaps.
Each mud flap set contains 4 flaps and mounting hardware (unless otherwise noted).
Recommended tools: Philips Screwdriver, 7/16th”wrench, 10mm wrench, small & long flat head screwdrivers.
Version 1.0 Release Date 03.16.2013 1

IMF 26
Front Mud Flap Installation
Begin by parking the vehicle on an even surface. Turn the steering wheel to allow access to the inner wheel well area.
• (Figure A) Remove front fender liner fastener located underneath the side skirt.
• (Figure B) Remove the three OEM fender liner fasteners (as shown). Carefully unclip front portion of side skirt by pulling the front
outer edge away just enough to release first two horizontal retainer clips. Pull liner away to gain access to the interior fender area.
• (Figure C) Place 3 polygon clips over mounting tabs at an angle (as shown). Re-install liner, do not re-install side skirt clips
• (Figure D) Using a wrench, remove the 10mm bolt hidden behind side skirt area.
• (Figure E) Mount square edge of front using the 10mm bolt, tighten until snug but adjustable. Round edge faces engine side. Place
polygon clip over round edge.
• (Figure F) Place the mud flap with the logo facing the rear of the vehicle, against the corresponding mounting points on the fender
liner and bracket. Place a washer (SmWash) over a long screw (1.5SS) of the original screws through the flap into the mounted clips
shown in image as “A”,”B”,”C”,”D”. Important- On the top most mount “A” place a spacer (.25SP) behind the mud flap.
Reinstall side skirt back into place. Align outer edge of the flap by incrementally adjusting the angle of the flap and walking away
from the vehicle until the flap is perpendicular to even ground. Tighten all mounting screws and bracket bolt only until snug.
Do not over tighten
•
Version 1.0 Release Date 03.16.2013 2