Rally Armor 2013+ Ford Focus User Manual

IMF 27

YOUR MOUNTING HARDWARE CONSISTS OF:

Quantity

Hardware Item

Item ID

2

Front brackets

HMF27-BR-FR

2

Rear Brackets

HMF27-BR-RE

6

Long Spacers

1 Sp 6 Short Spacers

.5sp

14

Round Edge Clips

RolCl

2

Short Stainless Steel Screws

1SS 6 Medium Stainless Steel Screws

1.5SS

6

Long Stainless Steel Screws

3SS

14

Washers

SmWash

2

“Wide” Inserts

Ins3 2 “Flat” Inserts

Ins5

INSERT GUIDE

SCREW GUIDE

HOW TO REMOVE STOCK FASTENERS

Cautionary Tip: The hardware is strong and self threading but over-tightening the mounting clips is not advised.
Installation Tip: To ease installation and avoid damage to existing OEM clips during removal, a well lit, climate controlled installation environment is recommended.
To the installer: Please return these instructions to the customer after installation. Always test and check wheel clearances before returning vehicle.
To the customer: Retain these instructions after installation. They may be necessary for installing other optional parts or removal of this accessory.

2013+ FORD FOCUS ST MUD FLAP INSTALLATION INSTRUCTIONS

PLEASE REVIEW THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING INSTALLATION

For high resolution color images of these instructions, please visit http://www.rallyarmor.com

To protect your Rally Armor mud flaps, care must be taken during parking and reversing. Rally Armor always recommends professional installation.

Check wheel clearances after installation, especially on vehicles outfitted with non-OEM offset wheels and suspensions. Adjust accordingly.

Rally Armor is not responsible for damage or loss of installed mud flaps.

Each mud flap set contains 4 flaps, mounting hardware and brackets (unless otherwise noted).
Recommended tools: Philips Screwdriver, Torx Screwdriver, small & long flat head screwdrivers. Jack/Jack stands for rear installation.

Version 1.1 Release Date 05.12.2013 1

IMF 27

Front Mud Flap Installation

Begin by parking the vehicle on an even surface. Turn the steering wheel as to allow access to the inner wheel well area.

• (Figure A) Remove the three OEM fender liner fasteners. Pull liner away to gain access to the interior fender area.

• (Figure B) Place 3 round edge clips over mounting tabs (as shown). Replace liner over the mounting points.

• (Figure C) Place a round edge clip over lowest mounting point of front bracket. Lay front bracket against logo side of the mud flap.

• (Figure D) Place the mud flap with the logo facing the rear of the vehicle, against the corresponding mounting points on the fender

liner and bracket. Place a washer (SmWash) over a medium screw (1.5SS) of the original screws through the flap into the mounted clips.
Use a short screw (1SS) with a washer for the lowest mounting point on the bracket. Do not fully tighten screws prior to aligning the
mud flap.

• (Figure E) Expanded diagram. TIP: Ensure the clip mounting points are visible through the liner prior to inserting the screws. You
can align them with a small pick or screw driver if needed, then align the screw by hand threading the first few turns. The screw must
thread through the rear of the clip.

• (Figure F). Align outer edge of the flap by incrementally adjusting the angle of the flap and bracket and walking away from the vehicle
until the flap is perpendicular to even ground. Tighten all mounting screws and bracket bolt only until snug and flush with the surface
of the mud flap. Do not over tighten

Version 1.1 Release Date 05.12.2013 2