Rally Armor 2012+ Fiat 500 User Manual
IMF25
YOUR MOUNTING HARDWARE CONSISTS OF:
INSERTS GUIDE:
Quantity
Hardware Item
Item ID
2
Front brackets
HMF25-BR-FR
2
Rear Brackets
HMF25-BR-RE
2
Inserts
Ins
2
Wide Base Inserts
Ins3
2
Spacers
.5Sp
6
Stainless Steel Lock Nuts
SSLnut
16
Washers
SmWash
4
Polygon Clips
PolCl
2
Short Stainless Steel Screws
1SS
2
Long Stainless Steel Screws
2SS
Cautionary Tip: The hardware is strong and self threading but over-tightening the mounting clips is not advised.
Installation Tip: To ease installation and avoid damage to existing OEM clips during removal, a well lit, climate controlled installation environment is
recommended.
To the installer: Please return these instructions to the customer after installation. Always test and check wheel clearances before returning vehicle.
To the customer: Retain these instructions after installation. They may be necessary for installing other optional parts or removal of this accessory.
2012+ FIAT 500 MUD FLAP INSTALLATION INSTRUCTIONS
PLEASE REVIEW THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING INSTALLATION
For high resolution color images of these instructions, please visit http://www.rallyarmor.com
To protect your Rally Armor mud flaps, care must be taken during parking and reversing. Check wheel clearances after installation,
especially on vehicles outfitted with non-OEM offset wheels and suspensions. Adjust accordingly.
Rally Armor is not responsible for damage or loss of installed mud flaps.
Each mud flap set contains 4 flaps, mounting brackets and hardware.
Required tools: Philips screwdriver, 7/16”wrench, 8mm wrench, Small pick, drill, Small pilot drill bit, ¼”(.25”) or 6.35mm drill bit, fine
tip marker, Jack/jack stands.
IMF25 Version 1.0 Release Date 3.4.2013 1
IMF25
Front Mud Flap Installation
Begin by parking the vehicle on an even surface. Turn the steering wheel toward the side you are working on to allow access to the
inner wheel well area.
• (Figure A) Remove both 8mm side skirt bolts and trim piece. You will re-use the fasteners to mount a portion of the mud flap.
• (Figure B) Place polygon clip (PolCl) over round edge of bracket. Place a washer (SmWash) over original 8mm bolts and thread
through the existing flap mounting point into the corresponding mounting points in the bracket.
• (Figure C) Place entire assembly against side skirt mounting area with the logo facing the rear of the vehicle, aligning both 8mm bolts
into their original location. Loosely thread both 8mm bolts. Pull upper portion of bracket slightly about half an inch as to bring closer to
edge of fender.
• (Figure D) Loosely thread lock nut (SSLnut) and washer (SmWash) on upper mounting point by hand first. Thread a washer (SmWash)
and short screw through lower mounting point on flap into polygon clip (PolCl) mounted on bracket.
• (Figure E) Align outer edge of the flap and bracket by incrementally adjusting the angle and width/coverage of the flap and walking
away from the vehicle until the flap is perpendicular to even ground. Tighten all mounting screws and bracket bolt only until snug. Do
not over tighten
• (Figure F) Expanded diagram. Larger diagram is available on last page of these instructions.
IMF25 Version 1.0 Release Date 3.4.2013 2
Loading...