Rally Armor 10-13 Mazda3-Speed3 User Manual

To protect your Rally Armor mud flap set, care must be taken during parking and reversing. Check wheel clearance after installation, especially vehicles outfitted

2

Short Screws

1SS

with non-OEM offset wheels and suspensions. Rally Armor is not responsible for damage or loss of installed flaps.

Each mud flap set contains 4 flaps for all 4 tires of the vehicle.
Recommended tools: Offset, ratcheting or stubby Phillips screwdriver, small flat head screwdriver, small snips or razor blade, drill and bit assortment, 7/16
ratchet /socket.

Rally Armor 2010+ Mazda3 and Mazdaspeed3

Quantity Hardware Item Item ID
8 Polygon Edge Clips PolCl
12 Washers Wash

6 Long Screws 1.5SS
4 Machine Screws 1MCHSS

4 Locknuts SSLNut

2 Rear Mounting Brackets Lbrkt

mud flap mounting hardware consists of:

To remove stock fasteners

Screw Reference

”

wrench or

The supplied hardware is strong and self threading but over-tightening the clips is not advised.

Installation Tip: To ease installation and avoid damage to existing OEM clips during removal, a well lit, climate controlled installation environment is recommended.
To the installer: Please return these instructions to the customer after installation. Always test and check wheel clearance before returning vehicle.
To the customer: Retain these instructions after installation. They may be necessary for installing other optional parts or removal of this accessory.

Front Mud Flap Installation

• (Figure A) Park vehicle on an even surface. Turn the steering wheel towards the side you are working on. Remove 4 outer fender
liner fasteners.

• (Figure B) Turn the steering wheel towards the opposite direction. Remove the remaining rear inner fender liner fasteners.

• (Figure C) Pull liner away to gain access to inner fender. Place a polygon clip (PolCl) over each of the 3 mounting points as shown.

IMF17 Version 1.0 Release Date 5.28.2010 1

• (Figure D) Replace liner. Confirm clips are visible through the mounting holes. Adjust clip with tip of screw or small pick if required.

• (Figure E) Position the front mud flap with logo facing the rear of the vehicle. Using a long screw (1.5SS) and a washer (Wash), loosely

bolt the mud flap to each 3 mounting points. Remount unused fender liner fasteners. Do not fully tighten mounting points.

• (Figure F) Align outer edge of the flap by incrementally adjusting the side to side, lower/upper portion of the flap and walking away
from the vehicle until the flap is perpendicular to even ground. Tighten all mounting screws only until snug against washer. Do not
over tighten.

Rear Mud Flap Installation

• (Figure G) Removal of rear wheel is not necessary but can ease installation. Jack up the rear of the vehicle enough to lower the tire
and enable access to the rear wheel well area.

• (Figure H) Remove the rear wheel fender liner fasteners and lower bolt underneath the liner.

• (Figure I) Remove liner from vehicle.

IMF17 Version 1.0 Release Date 5.28.2010 2