Rako Wp-conc User Manual

WP-CONC Instruction Manual

For programming information: Wired system Programming Guide

For general overview: Wired RAK Application Sheet

The WP-CONC is required for the following products:

WAPIR, WLED30CV4, WLED75CV1, WLED150CV1

What is the WP-CONC?

The WP-CONC is used to connect certain products to the Rako Wired network. It allows
cables to be connected to the wired network via a punchdown. It also provides termination
jumpers which must be set appropriately for the system to work correctly.

The wired system is most commonly configured in one of two ways:

“Daisy Chain” configuration - A single leg of wired devices runs from the RAK-LINK to an
end point. It is still usually advisable to run a return leg back to the RAK-LINK as a spare.

“STAR” configuration - Cables are all run back to a central point: a RAK-STAR usually
located with the RAK-LINK. Each cable can be from a single keypad or a leg of keypads.

WCM-070 Manual Version 2.0.1

Installation of the WCM with screwless finish plates (WLF/WLM):

Step 1

Prepare the WP-CONC for connection
by removing it from the case.

Prepare the junction box by cutting slots
in each side for cable entry/exit.

Step 2

Punch down cable(s) matching cable
colours to colours written on the circuit
board.

There may be either one or two sets of
cables to punch down.

Step 3

Terminate the WCM as required. See
“Terminating the WCM” on page 3 of
this manual.

TIP:

Take care when preparing and installing not
to disturb the punchdown connections.
Loops are provided on the back section to
cable tie the cable(s) if desired.

Step 4

Slot the circuit board into the junction
box.

FIx cable clamps, close lid and screw
close to complete installation.

WCM-070 Manual Version 2.0.1