Raise3D N2, N2 Plus Quick Start Manual

N2 N2 Plus

Quick Start Guide

N-Series 3D Printer

* Please review this entire guide before operating the printer.

N2 N2 Plus

N-Series 3D Printer

/ Quick Start Guide

A List of Parts

N2

Touch Screen

Nozzle(s)

Fan(s)

Z-Stage

Print Bed

Filament Feeder

Z Ball Screws

Power Inlet

Power Switch

USB Storage &
SD Card Slot

N2 Plus

Touch Screen

Nozzle(s)

Fan(s)

Z-Stage

Print Bed

Filament Feeder

Z Ball Screws

Power Inlet

Power Switch

USB Storage &
SD Card Slot

Wheels

GPIO Ports

GPIO Ports

N-Series 3D Printer

/ Quick Start Guide

B Hardware Installation

Recommend to unclip the Zipties as you
are able to reuse the ties later.

1

3

Remove!

(×2) Hex Wrench

(3 mm)

Use the 3mm hex wrench to remove the Z
axis clamps on both Z axis ball screws.
The 3mm hex wrench is packed under the
printing platform.

Please remove the 24 clips holding the
extruder assembly in place before power­ing on your printer. If you fail to remove
these clips your printer will be damaged.
Please save these clips and re-install them
if you transport your printer.

2

Remove!

(×24)

Remove!

Gently lift the build plate gently with
your hands and remove the accessory bag
under the build plate and open it for
standby. You can gently turn the ball screw

by hand to raise the z platform to help taking
out the accessory bag.

4

N-Series 3D Printer

/ Quick Start Guide

B Hardware Installation (continued)

List of Contents

Spatula

Filament

(×1/×2)*

Filament Holder

(×1/×2)*

Nozzle

Cleaning Kit

Glass with

Protective Foam

Hex Wrenches

2.5mm 2mm 1.5mm3mm

Fan Cover
(×0/×2)*

Tweezers

USB Storage Other Accessories

(Spare)

Filament Guide
Tube (×2/×4)*

Fuse

15A

10A

Build Plate Clips

Filament Guide

Tube Holder

Power Cable

* Due to the difference between single and dual extrusion machines, the quantity of some of the products
received will be different.
Besides, there is only one fan cover in the printer with single extruder and it is has already been equipped
to the printer.

N-Series 3D Printer

/ Quick Start Guide

B Hardware Installation (continued)

Remove the remaining build plate clips
from the accessory box and secure them
to the glass and heated bed plate.

NOTE: The best distance between the glass clip

and the edge of print platform is 5cm.

10

5cm5cm

Gently slide the glass plate. Make sure it
snaps into the build plate clamps at the
back.

NOTE: Place the surface which posted with

BuildTak upwards, while the yellow label is at the
back left corner. Make sure it snaps into the build
plate clamps in this way.

9

Remove the glass build plate from the
protective foam.

8

Protective Foam

Cover

Build Plate

Remove!

N-Series 3D Printer

/ Quick Start Guide

B Hardware Installation (continued)

The printer will go through a start-up
sequence. When the touch screen displays
"Home", the printer is ready.

10

Slide the starter box out of the base of the
printer.
Remove the power cable from the starter
box and plug the machine into a wall
outlet.

9

Install the filament holder in the mounting
hole on the side of the printer and place a
spool of filament on the holder.

NOTE: The filament should load clockwise.

A B

C D

8

Mounting

holes