A new way to see your energy
Quick Start GUIDE
NEED HELP WITH YOUR EAGLE-200?
For a full user manual, FAQs, and to contact support:
rainforestautomation.com/eagle200_support
LED LIGHT INDICATOR KEY
LED lights on the front of the device give you a quick way to check the
status of the EAGLE-200.
V1.01
WHAT’S IN THE BOX:
• EAGLE-200 ENERGY GATEWAY
• AC POWER ADAPTER
• ETHERNET CABLE
YOU WILL NEED:
• A BROADBAND INTERNET CONNECTION VIA
ETHERNET OR WIFI
• A COMPUTER OR DEVICE WITH A WEB BROWSER
rainforestautomation.com
POWER ETHERNET WIFI CLOUD ZIGBEE
Power is on.
IP address
obtained.
WiFi
network
is active
Connected to
the Cloud
Zigbee network
is active
Model:
RFA – Z114 – Z2 – 001 Control Gateway
Rainforest Automation, Inc.
Assembled in
New Hampshire U.S.A.
Contains FCC IDs:
YCXRFA – W900
2AC2E – 68M04
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions (1)
This device may not cause harmful
interference, and (2) this devic e
must accept any interference
received, including interference
that may cause undesired
operation.
Cloud ID: 123456
MAC: d8d5 b900 0000 0000
IN: e80f 63cd a532 0a3d
EAGLE-200 INFORMATION LABEL
Located on the underside of the EAGLE-200 is the Information Label that
identifies each individual device. You will need the three numbers
indicated below to register the device. Please make a note of them:
Cloud ID (6 characters)
Install Code (16 characters)
MAC Address (16 characters)
GET DIRECT ACCESS TO YOUR REAL-TIME
ENERGY INFORMATION IN THREE
EASY STEPS:
STEP 1: REGISTER WITH YOUR UTILITY
You will need to provide your MAC Address and Install Code from
the Information Label on the bottom of your EAGLE-200. It may take
some time for your utility to enable your meter to connect to your
device. It is important to wait until this is complete before
proceeding to the next step.
STEP 2: PLUG IN YOUR EAGLE-200
Connect the Ethernet cable to your router (to use WiFi instead, see
the EAGLE-200 User Manual on our website), and plug in the power
adapter. Use only the included adapter to power your EAGLE-
200. If another adapter is used, it may cause permanent damage
to your EAGLE-200.
It should take about two minutes for your EAGLE-200 to boot up.
STEP 3: CONNECT TO THE CLOUD
Create your Cloud Account and connect to your EAGLE-200 to start
viewing your energy data.
rainforestcloud.com
• Click on “Register” in the top right of the screen.
• Fill in the “Account Registration” form and click “Register”.
• Check your email to find the message from Rainforest Automation
with the subject line “EAGLE Cloud Account activation”. Click the
“SETUP PASSWORD FOR MY ACCOUNT” link in the email.
• Set up your password and click “Activate Account”.
• Click on “Settings” in the top right of the screen.
• Click “Add New EAGLE”.
• Enter the Cloud ID and Install Code from the label of your EAGLE
and click “Add EAGLE”.
• Close the window and click “Home” in the top right of the screen to
see your real-time data.
SEE THE FULL EAGLE-200 USER MANUAL ON OUR WEBSITE:
rainforestautomation.com/eagle200_support
CONNECTING TO THE CLOUD
Use your Web Browser to go to rainforestcloud.com
Loading...