#R172288 1½" & 2" SLIP
SPRING CHECK VALVE
• Special corrosion resistant 1½" & 2" slip spring check valve can be used
• to check back flow of fluids, air, etc.
• Full free flow design
• Special Spring and Seal for corrosive applications.
• Enclosed spring insuring free operation.
• Very effective when used in conjunction with chlorinator to check back flow
• of chemicals to pool/spa equipment, preventing corrosion problems
• and damage.
• Can be mounted in any position.
Suction from pool/spa
Typical check valve installation
NOTE: If heaters are used, a Fireman’s
Switch or other safety device must be
installed to prevent possible damage and
improper operation of Check Valve and
other equipment subject to heat damage.
Sanford, NC
Moorpark, CA R24049-0201
EQUIPMENT SAFETY
CAUTION
PLEASE READ CAREFULLY
Since most pool’s plumbing is not airtight, and a mixture of air and chlorine is
highly corrosive to metals, it is important to protect these items from corrosion
in the OFF period when no circulation is taking place. (There is no chance for
chlorine corrosion when the circulating system is in operation.)
Of course, corrosion or erosion of metal components can still occur
independently of any chlorinator installation for the following reasons:
1. Water velocity too high.
2. Water pH less than 7.2.
3. Total alkalinity less than 100 PPM.
If your pool or spa has any of the following equipment, special plumbing
procedures must be followed for safe operation:
1. Brass or bronze gate, rotary or backwash valves.
2. The preceding valves constructed of PVC or other plastic material
with metallic shafts.
3. Filters, heaters, heat exchanges or other items with metallic tanks,
shafts, coils or tubes.
4. NOT FOR USE IN COPPER PLUMBING.
Installation of the OPTIONAL Rainbow #R172288 positive seal, corrosion
resistant check valve SHOWN ON REVERSE SIDE will prevent the backflow of
corrosive liquids and gases that can damage equipment containing metallic
components. Examples listed above.
WARNING: If your pool is equipped with a permanent built in
pool-cleaning system, damage could occur to that system if materials
are not compatible with low pH Tri-Chloro feeders. Check with
manufacturer for compatibility.