BD45XXXG and BD46XXXG are series of high-accuracy detection voltage and low current consumption
VOLTAGE DETECTOR ICs adopting CMOS process. New lineup of 156 types with delay time circuit
have developed. Delay time is fixed in the IC due to the built-in counter timer to require no external
capacitor. Total 156 types of VOLTAGE DETECTOR ICs including BD45XXXG series (Nch open drain
output) and BD46XXXG series (CMOS output), each of which has 26 kinds in every 0.1V step (2.3~4.8V)
and three kinds of delay time (50msec, 100msec, 200msec) have developed.
Applications
Every kind of appliances with microcontroller and logic circuit
Features
1) Built-in delay time circuit
(Fixed delay time by the built-in ±10% of high-accuracy counter timer)
2) No external capacitor for setting delay time required
3) 3 kinds of delay time: 50msec(Typ.)(BD45XX5G,BD46XX5G)
100msec(Typ.)(BD45XX1G,BD46XX1G)
200msec(Typ.)(BD45XX2G,BD46XX2G)
4) Detection voltage: 2.3V ~ 4.8V 0.1V step
5) High-accuracy detection voltage: ±1.0%
6) Ultra low current consumption: 0.85µA typ.
7) Output circuit: Nch open drain(BD45XXXG)
CMOS(BD46XXXG)
8) Package: SSOP5(SMP5C2)
9) Operating temperature range: -40°C ~ +105°C
BD45XXXG
BD46XXXG
1
2
2.9±0.2
(5)
0.2
0.1
0.2
–
+
±
1.6
2.8
±
1.1
1.25MAX
SSOP5(SMP5C2)
5
4
1pin : External RESET
control
2pin : Connect to
Sub, GND
3pin : GND
3
4pin : VOUT
5pin : VDD
(UNIT:mm)
(4)
0.2MIN
(2)(1)
(3)
0.05
0.95
0.05
±
0.05
0.42
0.1
0.13
+
–
0.05
0.04
+0.05
–0.03
Application Circuit
BD45XXXGBD46XXXG
VDD
Reset
Vout
12345
ERSub GND VOUT VDD
Vref
VDD
VDD
GNDER
Oscillation circuit
counter timer
Pin No.
SSOP5
Vref
VDD
VDD
GND
Oscillation circuit
counter timer
ER
Vout
Reset
1/4
Voltage detectors
Absolute Maximum Ratings (Ta=25˚C)
Parameter
Power supply voltage
Output
voltage
ER pin input voltage
Power dissipation:SSOP5
Operating temperature range
Storage temperature range
∗1 Derating: 5.4mW/˚C for operation above Ta=25˚C.(Mounted on a 70.0mmX70.0mmX16mm glass epoxy PCB.)
No technical content pages of this document may be reproduced in any form or transmitted by any
means without prior permission of ROHM CO.,LTD.
The contents described herein are subject to change without notice. The specifications for the
product described in this document are for reference only. Upon actual use, therefore, please request
that specifications to be separately delivered.
Application circuit diagrams and circuit constants contained herein are shown as examples of standard
use and operation. Please pay careful attention to the peripheral conditions when designing circuits
and deciding upon circuit constants in the set.
Any data, including, but not limited to application circuit diagrams information, described herein
are intended only as illustrations of such devices and not as the specifications for such devices. ROHM
CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any
third party's intellectual property rights or other proprietary rights, and further, assumes no liability of
whatsoever nature in the event of any such infringement, or arising from or connected with or related
to the use of such devices.
Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or
otherwise dispose of the same, no express or implied right or license to practice or commercially
exploit any intellectual property rights or other proprietary rights owned or controlled by
ROHM CO., LTD. is granted to any such buyer.
Products listed in this document use silicon as a basic material.
Products listed in this document are no antiradiation design.
Notes
The products listed in this document are designed to be used with ordinary electronic equipment or devices
(such as audio visual equipment, office-automation equipment, communications devices, electrical
appliances and electronic toys).
Should you intend to use these products with equipment or devices which require an extremely high level of
reliability and the malfunction of with would directly endanger human life (such as medical instruments,
transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other
safety devices), please be sure to consult with our sales representative in advance.
About Export Control Order in Japan
Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control
Order in Japan.
In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause)
on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction.
Appendix1-Rev1.0
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.