Raijintek Samos NV2080Ti RBW User Manual
Creating Passion
MODE
-
SPEED
+
MODE
+
AUTO
SPEED
-
SAMOS
NV2080Ti-RBW
SAMOS SERIES LIQUID COOLING GRAPHIC CARD WATER BLOCK
OUTIN
Precautions
1.Keep and store the product away from the reach of children.
2.Check the component list and condition of the product
before installation. If there is any problem, contact the shop
where you purchased to get a replacement or refund.
3.RAIJINTEK Co., Ltd. is not responsible for any damages due
to external causes, including but not limited to, improper use,
problems with electrical power, accident, neglect, alteration,
repair, improper installation, and improper testing.
4.GPU and VGA card are subject to damage if the product in
incorrectly installed.
5.This product is a water cooling solution device, once taken
apart or any use of non RAIJINTEK’s accessories, will lead to
a warranty loss.
6.Liquid contaminations of other objects are in no matter
under warranty due to maintenance or possible misuse.
VGA water block × 1
A
Washers × 15
E
Remove the screws circled on the
diagram. All Back-plate and Heat-sink
assembly screws should be removed
Back plate × 1
B
M2 L6 screw × 10
F
Remove the power connector of fan,
and carefully detach the original stock
cooler
C
Connect to MB 5V ADD Header Connect to RJK RBW-ADD
Control Hub
Thermal Grease × 1
C
M2 L10 screw for back plate × 6
G
Thermal pad × 4
D
Stick the VGA water block on
the VGA card. Align the screws
onto the screw holes on the
VGA card. Pay attention to
the pressure applied during
installation. Do not press the
VGA water block and PCB
board too hard.
1
F
Fasten the spring screw from
backside (Place the insulation
washer on the screw hole)
Clean the original thermal
the GPU die and
thermal pad.
grease off
D
Cut the thermal pads to place on the
heat-emanating chips.
Apply Thermal grease on GPU
evenly.
D
D
D
Precaution: Besides GPU that needs
to have thermal grease applied on it, the
heat emanating chip on the VGA card
also needs the thermal pads to be
attached on it, or the card will burn out.
D
D
E
2
G
Once installing VGA water
block is done, place the back
plate and fasten the screws on
it.
E
Precaution:
screws until the VGA water
block is balanced. To avoid
damaging the chip, do not
fasten the screws to the point
where it cannot be
anymore.
Fasten the
screwed
3 4
Loading...