RAIDON GR3660-B3 Installation Guide

GR3660-B3

Product Diagrams and Contents of Product Package

Status No HDD Standby

LED Instruction

Data

access

HDD
failed

Sleeping or

Host unplugged

Rebuilding

CAUTION

Please ensure each plug is properly
connected before turning on the power.

POWER

USB 3.0

ON/OFF

DC

12V IN

RAID 0 RAID 1 JBOD

Front View

HDD -1-2 Access

Tray Handle

Rear View

Fan

Power Switch

12V DC IN

RAID Mode

USB3.0 Port

After you open the outer package, make sure that the following items are contained in the package:

Contents of Product Package

GR3660-B3 Device x1

USB 3.0 Cable x1 Quick Guide x1

Power Adaptor x1

Please make sure that the related accessories and product body are not damaged or missing. If you
have any question, please contact the local distributor or the retailer you purchase from for help.

Power Cable x1

Product Package x1

v1.0 (July. 2014)

Blue

Blue

Blue

Red

lights on

Red

lights on

----

----

Source:

Blue Blinking

Target:

Red and Blue

Blinking

----

Blue

RAID 0 ----

RAID 1 ----

JBOD ----

Red

lights on

Red

lights on

Red

lights on

lights on

Blue

lights on

Blue

lights on

blinking

blinking

blinking

Please refer to the following procedures for the hardware installation of GR3660-B3:

1. Install your hard disks into the removable trays and secure them with the screws from accessory
kit. This will protect your hard disk from any unnecessary movement.

2. Once the hard disks have been installed, insert the removable trays into device and close
the handles.

Install HDD

3. Configure the RAID level via the RAID mode switch from the back panel. (RAID 0, 1 & JBOD)

4. Connect the related cable to the correct plugs.

Install SSD

CAUTION

Please ensure each plug is properly
connected before turning on the power.

POWER

USB 3.0

ON/OFF

DC

12V IN

RAID 0 RAID 1 JBOD

Computer USB Port

5. Hardware installation is now complete. Please power on the unit and follow the OS indications to
format the hardware. After the configuration is completed you may access the data.

※ Whenever needed an SSD/HDD swap, just simply unlock the tray and releases it from the tray
handle to exchange for the requiring SSD/HDD.

1. Please always connect the USB cable to the computer to ensure the energy saving function
operating normally.

2. GR2660-B3 supports RAID 0 (Striping), RAID 1 (Mirroring) and JBOD. Please configure the
RAID level before powering on.

3. If you reset the RAID mode later on, it would destroy the data in the disks. Please backup the
data before configuring the RAID mode.

4. Once the computer turn to “Standby” or “Sleep” mode, GR2660-B3 will still complete the rebuilding
function. However, it will not change to “Standby” mode after rebuilding. You need to shut down
the GR2660-B3 manually or wake up the computer to synchronize “Standby ” or “Sleep” mode
together.

5. GR2660-B3 is utilizing the 12V adapter, please DO NOT use the 5V adapter to avoid the machine
and data failure.

6. Do not remove the hard drive(s) while the system is powered on. Always remember to power off the
system when removing the hard drives.