Radio Shack 63-898A, 04A01 User Manual

LCD Jumbo Display Dual Timer/Clock
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack LCD Jumbo Display Dual Timer/Clock is a precise, dual-purpose time­piece. Both timers can count hours, minutes and seconds, up or down, from a specified time. The metal stand lets you set the timer/ clock on a desk or table, and the clip and magnet let you attach it almost anywhere.
Countup Timer —
counts up to 29 hours, 59
minutes and 59 seconds.
Countdown Timer —
counts down from 29
hours, 59 minutes and 59 seconds.
Minute and Second Increments —
let you
count even small amounts of time.
Alarm —
alerts you when the countdown
time elapses.
INSTALLING THE BATTERY
Your must install the supplied LR44 button­cell battery before using your timer/clock.
1. Insert a coin into the groove on the battery compartment cover, turn the coin counter­clockwise, and remove the cover.
Cautions:
• Keep button-cell batteries away from children. Swallowing a button-cell battery can be fatal.
• Dispose of old batteries promptly and properly. Do not burn or bury them.
Notes:
• If the timer/clock does not work when you install the battery, remove and re­install it.
• When the display dims or the alarm weakens, replace the battery. For the best performance and longest life, we recommend using a RadioShack alkaline battery.
SETTING THE CLOCK
1. Repeatedly press appears in the upper left corner.
MINUTE
HOUR
CLEAR
MODE
until
CLOCK
SECOND
MODE
2. Insert the battery with the positive (+) side facing up. The timer/clock beeps.
3. Replace the cover.
TIMER 2
2. Hold down
CLEAR
TIMER 1
for about 2 seconds
until the display flashes.
Repeatedly press
Note:
change between a 12- and 24-hour for-
2001 RadioShack Corporation. All Rights Reserved.
©
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
CLEAR
to
PM
mat.
appears for PM hours when the
12-hour format is selected.
3. Repeatedly press (or hold down) until the correct hour appears.
4. Repeatedly press (or hold down)
MINUTE
until the correct minute appears.
5. Repeatedly press (or hold down)
until the correct second appears.
OND
Note:
When you hold down
SECOND
, the setting advances in incre-
MINUTE
ments of 10.
HOUR
SEC-
or
COUNTING DOWN
You can use the two countdown timers for ac­tivities that require a predetermined amount of time, such as baking a cake or playing a game. The timers count down in 1-second in­crements.
Note:
The maximum countdown time is 29
hours, 59 minutes and 59 seconds.
CLOCK
1. While twice.
Notes:
TIMER 1
appears, press
0:00 00
and
appear.
MODE
6. Press
or wait until the display
MODE
stops flashing. The clock is now set.
COUNTING UP
Each timer can count up to 29 hours, 59 min­utes and 59 seconds. Then they reset and be­gin counting from
0:00 00
use the timers separately or together.
1. While
CLOCK
appears, press
COUNT UP1, COUNT UP2
timers appear.
Note:
If either timer does not show
00
, press
2. Press
TIMER 2
TIMER 1
(for
counting up.
Note:
You can start
COUNT UP2
ing
TIMER 1
3. Press
4. When both timers have stopped, press
TIMER 1
ing up. Press again to continue counting up.
to reset them to
CLEAR
to reset both timers.
CLEAR
(for
COUNT UP 2
at the same time by press-
and
TIMER 2
or
again. You can
COUNT UP1
COUNT UP1
together.
TIMER 2
to stop count-
0:00 00
MODE
, and their
0:00
) or
) to start
and
.
• To use TIMER 2, press
times.
TIMER 2
appears.
• To use both timers, press
TIMER 1
times. appear. Then press
to set each timer.
2
2. Repeatedly press (or hold down) until the desired hour appears.
.
3. Repeatedly press (or hold down) until the desired minute appears.
4. Repeatedly press (or hold down)
until the desired second appears.
OND
Note:
When you hold down
MINUTE
, or
SECOND
advances in increments of 10.
5. Press
TIMER 1
or
TIMER 2
ing down.
Notes:
• Both timers can be run at the same
time.
• To pause the countdown before the
timer reaches
or
TIMER 2
1
0:00 00
. To resume the count-
down, press the same button again.
three
MODE
MODE
TIMER 2
and
TIMER 1
or
MINUTE
TIMER
HOUR
HOUR
, the setting
to start count-
, press
TIMER
four
SEC-
,
2
• To stop the countdown before the timer
Clip
Magnet
Stand
reaches
TIMER 2
resets to
When the timer reaches sounds for 1 minute and above the active timer. Then, the timer counts up in 1-second increments. Press any button to silence the alarm.
0:00 00
, then press
0:00 00
0:00 00
TIMES UP
, press
CLEAR
.
TIMER 1
. The timer
, the alarm
or
flashes
Using the Stand
1. Press down the upper end of the clip.
2. Use a pencil tip to pull the small stand out until it fits onto the clip.
When the alarm stops, to flash and the timer continues to count up. To stop the count, press the active timer’s but­ton. The timer resets to
TIMES UP
0:00 00
continues
.
USING THE CLOCK AND TIMERS
You can view the clock and use the timers at the same time.
1. After you set the count up or countdown
CLOCK
timers, press in the upper left corner. The active timer(s) flash.
2. Repeatedly press between viewing the clock and the timers.
MODE
until
MODE
appears
to switch
MOUNTING THE TIMER/ CLOCK
The magnet on the back of the timer/clock at­taches to any metal surface, such as a refrig­erator, oven or file cabinet.
You can also clip the timer/clock to a clipboard or your clothing. Press down the upper end of the clip, attach it to your clipboard or clothing, and release the clip.
3. Set the timer on a table or desk.
CARE
Keep the timer/clock dry; if it gets wet, wipe it dry immediately. Use and store the timer/clock only in normal temperature environments. Handle the timer/clock carefully; do not drop it. Keep the timer/clock away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.
Modifying or tampering with the timer/clock’s internal components can cause a malfunction and might invalidate its warranty. If your timer/ clock is not performing as it should, take it to your local RadioShack store for assistance.
SPECIFICATIONS
Operating Voltage ............................ 1.25 to 1.65 V
Power Source .......... One LR44 button cell battery
Battery Life ......................................... About 1 year
Operating Temperature ............ 32–122 F (0–50 C)
Time Deviation ...................... 0.67 sec/day at 1.5V
×
Dimensions (HWD) .......... 1¼
Weight ................................................ 2.5 oz (71 g)
25/8 × 33/8 Inches
×
(32
67 × 86 mm)
Specifications are typical; individual units might vary. Specifications are subject to change and im­provement without notice.
3
Limited One-Year Warranty
This product is warranted by RadioShack against manufacturing defects in material and workman­ship under normal use for one (1) year from the date of purchase from Radi oSha ck company- owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUD­ING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIM­ITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RE­SPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT T O ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFOR­MANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, IN­CLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDEN­TAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limit a­tion of incidental or consequential damages, so the above limitations or exclusions may not apply to you. In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un­less otherwise provided by law: (a) correct the defect by product repair without charge for parts and labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, become the prop­erty of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period. This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up service adjustment or reinstallat i on. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
We Service Wh at We Sell
12/99
RadioShack Corporation Fort Worth, Texas 76102
63-898A
04A01
Printed in Hong Kong
Loading...