Radio Shack 63-234 User Manual

Talking Picture Frame

m o t i o n - a c t i v a t e d

6 3 - 2 3 4

U s e r ’s G u i d e

Please read this user’s guide before using
your new Picture Frame.

Package contents

 Talking Picture Frame
 Bolts (2)
 User’s Guide
 Quick Start

Features

 Record a message to go with your favorite

picture.

 Message plays back when the sensor detects

motion.

1 Install Batteries

Insert four AAA batteries (not included)
according to the polarity symbols marked
inside.

2

AAA

AAA

AAA

AAA

b Battery Notes:

 Dispose of batteries promptly and

properly. Do not burn or bury them.

 Use only fresh batteries of the required

size and type.

 Do not mix old and new batteries,

different types of batteries (alkaline, or
rechargeable), or rechargeable batteries
of different capacities.

 If you do not plan to use the picture

frame for a long time, remove the
battery. Batteries can leak chemicals that
can damage electronic parts.

3

2 Put a Picture in the Frame

1. Lift the clear faceplate off the back

panel.

2. Place a 5 × 7” picture on the back panel.

3. Align the magnets on the faceplate and

back panel, then snap the tabs into slots
on all four sides to hold the picture in
place.

Snap together
(all four sides)

4

3 Insert the Bolts

Screw the two supplied bolts into the holes
on the back of the frame to stand your
picture frame horizontally or vertically.

Sensor

5

4 Record Your Message

1. Slide REC/LOCK to REC. Hold the MIC

about two inches from your mouth.

2. Hold down REC. The red indicator

lights. Record for up to 10 seconds, then
release REC.

3. Slide REC/LOCK back to LOCK.

nNote: To record, make sure playback is

not in progress.

5 Play the Message

Wave your hand over the sensor to play
the message. When finished, the indicator
flashes once.

6

nNote: Your picture frame will

automatically play the message when you
turn the lights in the room on or off.

Specifications

Power Source ......................... Four AAA Batteries

Recording Time ........................10 Seconds (Max.)

Operating Temperature ............32–104°F (0–40°C)

Dimensions ..................................5.9 x 8.7 x .88 in

.............................................(152 × 220 × 22 mm)

Weight .............................................. 12 oz. (340g)

Specifications are subject to change and improvement
without notice. Actual product may vary from the images
found in this document.

Limited Warranty

Ignition L.P. warrants this product against defects in materials and
workmanship under normal use by the original purchaser for ninety (90)
days after the date of purchase. IGNITION L.P. MAKES NO OTHER
EXPRESS WARRANTIES.

This warranty does not cover: (a) damage or failure caused by or attributable
to abuse, misuse, failure to follow instructions, improper installation or
maintenance, alteration, accident, Acts of God (such as floods or lightning),
or excess voltage or current; (b) improper or incorrectly performed repairs
by persons who are not a Ignition L.P. Authorized Service Facility; (c)
consumables such as fuses or batteries; (d) ordinary wear and tear or
cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs
of product removal, installation, set-up service, adjustment or reinstallation;
and (g) claims by persons other than the original purchaser.

Should a problem occur that is covered by this warranty, take the product
and the sales receipt as proof of purchase date to the place of purchase.

7

Ignition L.P. will, at its option, unless otherwise provided by law: (a) repair
the product without charge for parts and labor; (b) replace the product
with the same or a comparable product; or (c) refund the purchase price.
All replaced parts and products, and products on which a refund is made,
become the property of Ignition L.P. New or reconditioned parts and
products may be used in the performance of warranty service. Repaired or
replaced parts and products are warranted for the remainder of the original
warranty period. You will be charged for repair or replacement of the
product made after the expiration of the warranty period.

IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDI­TIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WAR­RANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED
WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE
ON THE EXPIRATION OF THE STATED WARRANTY PERIOD.

EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO
LIABILITY OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT
OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY,
LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE
OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY
BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY
DAMAGES RESULTING FROM INCONVENIENCE AND ANY LOSS OF
TIME, DATA, PROPERTY, REVENUE, OR PROFIT AND ANY INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF
IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.

Some States do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This warranty gives
you specific legal rights, and you may also have other rights which vary from
State to State. You may contact Ignition L.P. at:

Ignition L.P., 3102 Maple Ave Suite 450, Dallas, TX 75201 02/09

For product support, call 1-866-315-0426.

Protect the environment by recycling used electronics. Go to
E-CyclingCentral.com to find an electronic recycling center
near you.

© 2010. Ignition L.P. All rights reserved.

Print ed
in China

01A10

63-234

8