Radio Shack 61-3005 User Manual

installing your wall switch

61-3005

operating your wall switch

setting up your wall switch

what’s included

home automation

wall switch

Wall Switch

Wire nuts

Screws

Thank you for purchasing the RadioShack Home
Automation Wall Switch. Your Wall Switch is
designed to control incandescent lights only,
with rating between 40W and 500W. It replaces
your existing switch, and controls both indoor
and outdoor ceiling lights. A push button is
provided for local on/off control.

 Turn the power off at the circuit breaker

panel.

 Remove your wall plate and unscrew

the existing switch from its box.

 Disconnect the wiring from your

existing switch, and connect the two
wires on your new switch using the
wire nuts provided.

Wires

Note

 Screw the switch into its wall box.

Warning

Be sure no loose wires are protruding;
use insulating tape (not provided) to
cover the wire nuts, if necessary.

Wall switches must not be used to
control appliances, low voltage lamps
or fluorescent lamps!

 Set the House Code

dial to the same letter
that you set on your
Controller.



Set the Unit Code
dial to an unused code.

 Turn the ON/OFF

switch beneath the
push button to ON
(center position).

 Replace the wall plate

on your wall box.

ON/OFF

Push

button

 Turn the power back on at the circuit

breaker panel.



Push the button to turn your wall switch
on or off.

When replacing a light bulb, turn

Note

WARNING: To reduce the risk of fire or shock hazard, do not expose this
product to rain or moisture.

your wall switch to OFF
(left position).

2 screws 2 wire nuts

wall switch user’s guide

©2004. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com are
trademarks used by RadioShack Corporation.

Please read this User’s Guide before

installing, setting up, and using your new product.

www.radioshack.com

61-3005

06A04

Printed in China

DO NOT OPEN.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.

This symbol is intended to alert you to the presence of
uninsulated dangerous voltage within the product’s enclosure
that might be of sufficient magnitude to constitute a risk of
electric shock. Do not open the product’s case.

This symbol is intended to inform you that important
operating and maintenance instructions are included in the
literature accompanying this product.

RISK OF ELECTRIC SHOCK.