Radio Shack 61-2403 Owner's Manual

©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
61-2403
OWNER’S MANUAL — Please read before using this equipment.
....
/1706+0)"6*'"
574)'"2416'%614
You can place the surge pro tector o n a lev el surface or mount it on a wall. Select a location that is:
• near a grounded AC outlet.
#
• out of the way of normal activities.
R
1. Use the supplied mounting template to mark the holes on the selected location.
2. Drive in two wood scre ws (not supp lied) with heads that fit into the key hol e sl ots on the bottom of the surge protector.
±
3. Align the surge protector’s keyho le slots with the wood screws, then press the surge protector down to secure it.
%100'%6+105
1. Connect your electronic equipment’s grounded AC cord plug(s) to the surge protector’s AC sockets. The adapter socket is separated by a wid er space so you can connect your electronic device’s AC adapter.
2. Plug the surge protector’s AC power cord into a three-prong standard grounded AC outlet.
%106'065
Mounting the Surge Protector ..................... 1
Connections ................................................ 1
Operation ................................ .................... 2
Using the Safety Slide Cover ................... 2
Using the Indication Tags ......................... 2
Troubleshooting .......................................... 2
Care ........... ............... ........................... ....... 2
Service and Repair ...................................... 2
Specifications ..................................... ......... 3
#
"+/2146#06"
#
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.
— Warning # — Important
.... — Caution
±
— Note
.
"%#76+10"
.
• This product is intended for indoor use only.
• This surge protector is not a lightning arrestor and might not protect against lightning-induced voltage surges.
• Be sure the total wattage of all connected devices does not exceed 1,875 watts.
• Use the surge protector only with a three­prong standard AC plug. The surge protector cannot provide protection without a grounded AC source.
PROTECTED WH EN LIT Indica tor — Lights when the connected devices are protected.
Swift Detection and Protection — Detects and protects against a power surge of up to 6,000 volts and 42,500 amps in 1 nanosecond (1 billionth of a second).
Power Shutdown Protection — Protects the connected appliances from being damaged by shutting down power when surge protection is depleted (see “Troubleshooting” on Page 2).
Indication Tags — Identify which device’s power cord is connected to which AC socket, so you can avoid disconnecting the wrong device.
Safety Slide Covers — Prevent children from inserting metal objects into the unused AC socket(s).
Power ON Indicator —
Lights when the power is turned on.
AC Adapter Spacing — Lets you plug an AC adapter into your surge protector.
POWER — Press to turn the surge protector on.
RESET — See
“Troubleshooting” on Page 2.
Safety ON
Safety OFF
#
"+/2146#06"
#
Operating this surge protector from a non­grounded outlet will invalidate your “Connected Equipment Guarantee” and puts your valuable equipment at risk.
R
"9#40+0)
ý
R
"
Do not use the surge protector with an aquarium or near wet locations.
±
"016'"±"
• Use appropriate mounting anchors if you are mounting the surge protector to drywall.
• The appropriate screw size is shown on the mounting template.
9/1WVNGV"#RRNKCPEG"5WTIG"5VTKR
2
12'4#6+10
Press
POWER
to turn on the surge
protector.
±
Your connected devic es ar e pr otected w hen the PROTECTED WHEN LIT and ON indicators light.
If any of the indicator lights fail, see “Troubleshooting”.
75+0)"6*'"5#('6;"5.+&'" %
18'4
Your surge protector is equipped with safety slide covers on each of its seven AC sockets. Slide the cover up to protect each unused AC socket.
75+0)"6*'"+0&+%#6+10"6#)5
Your surge protector comes with pairs of indication tags to identify which device’s power cord is connected to which AC socket. Stick a large color tag on the power cord at the rear of the device and the same color small tag next to the surge protector’s target AC socket.
6417$.'5*116+0)
Condition
The PROTECTED WHEN LIT and ON indicators turn off, and
RESET
pops out.
Solution
Your surge protector received a current that exceeded its capacity due to overload. When this happens, the 15-amp circuit breaker (located on the side of the case) trips to prevent possible damage, and
RESET
pops out. To reset the surge protector, disconnect one or more of the connected devices and allow the surge protector to cool down . Then push
RESET
in.
Condition
The PROTECTED WHEN LIT and ON indicators turn off, and the surge protector sounds an alarm.
Solution
Your surge protector's AC line is no longer protected from surges and power is not allowed to pass beyond th e alarm. When the surge protector recei ves an unusua lly strong surge, the built-in protection absorbs the surge to protect your equipment. If the surg e is strong enough, it d iminishes the prote ction circuitry’s ability and the surge protector sounds an alarm. If the PROTECTED WHEN LIT and ON indicato rs will not light, replace the surge protector.
....
%#4'
Keep the surge protector dry; if it gets wet, wipe it dry immediately. Use and store the surge protector only in normal temperature environments. Handle the surge protector carefully; do not drop it. Keep the surge
protector away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.
5'48+%'"#0&"4'2#+4
If your surge protec tor is not perform ing a s it should, take it to your local RadioShack store for assistance. Mod ify ing or tam pe ring with the surge protector’s internal components can cause a malfunction and might invalidate its warranty.
±
"016'"±"
When you are not using the surge protector, press POWER so it pops up to turn off the surge protector. The PROTECTED WHEN LIT, and ON indicators turn off.
.
"%#76+10"
.
Retain Instr u c t i o n s — Retain the safety and operating instructions for future reference.
Damage — Unplug this appliance from the wall outlet and replace it:
• When the power cord or plug is damaged.
• If liquid has been spilled or objects have fallen into the appliance.
• If the appliance has been exposed to rain or water.
• If the appliance has been dropped or damaged in any way.
• When the PROTECTED WHEN LIT indicator fails to light.
Loading...
+ 2 hidden pages