Radio Shack 61-140 User Manual

61-140

User’s Guide

Wireless

Two-Bell Door Chime

Thank you for purchasing your Two-Bell Door Chime from RadioShack. Please read this user’s guide before installing, setting up, and using your new door chime.

Package Contents

• Wireless Door Chime • Nylon lanyard

• Bell 1 • Bell 2

• Remote Mounting Bracket (2)

• M 3 Screw (4) • Anchor (5)

• M 2.6 Brass Screw (2) • M 3.5 Screw (5)

• User’s Guide • Quick Start

1 Select Channels

1. Remove the battery compartment covers on the door chime and the two bells.

2. Select the same channel (1, 2, or 3) in the door chime and doorbell 1.

3. Repeat step 2 for the doorbell 2.

Bell 1 Bell 2

Channel Switch

Must be set to same channel

Door Chime

Channel Switch

Must be set to same channel

nNotes:

• Remove batteries and follow above steps to change or reset the channel on your door chime and remote doorbells.

• If your door chime rings when no one presses one of the remotes, you may be receiving interference. Switch the affected door chime and doorbell to another channel.

2 Install Batteries

1. Insert three C batteries in your door chime as indicated by the polarity symbols (+ and – ).

2. Insert three AAA batteries in each remote doorbell as indicated by the polarity symbols (+ and – ).

3. Replace the covers.

Notes:

• Replace the door chime’s batteries if it buzzes and the LED ﬂashes red.

• Replace the doorbell’s batteries if the LED turns off.

• Use only fresh batteries of the required size and type.

• Dispose of old batteries promptly and properly. Do not burn or bury batteries.

• Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.

• If you do not plan to use the alarm for a month or longer, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.

3 Mount Your Door Chime

You can mount your door chime on a door or wall, or set it on a ﬂat surface using the attached metal stand. To mount to a door or wall:

1. Drill a ¼ inch hole in the door or wall and insert an anchor.

2. Screw an M 3.5 screw into the anchor, leaving the head

extended about

inch.

3. Align the door chime’s rear keyhole slot to the screw head and slide the chime down to lock in place.

- OR -

4 Mount Your Doorbell

1. Mark two holes using the mounting bracket as a guide. Drill a ¼ inch hole at each mark. Insert an anchor in each hole.

2. Align your mounting bracket with the anchors and screw a supplied M 3.5 screw into each anchor.

3. Slide your doorbell into the bracket. To lock the doorbell in place, insert a supplied M 2.6 screw into the bottom of the mounting bracket.

- OR -

You can also use the supplied lanyard to carry your doorbell with you as a panic alarm or to let someone know you have arrived.

1. Slip the small end through the hole at the top of the remote doorbell.

2. Thread the thick end through the loop at the thin end and pull through.

5 Use Your Door Chime

1. Slide your door chime to ON.

2. Press the button on one of your doorbells. Your

chime will “ding dong” for doorbell 1 and play “Home Sweet Home” for doorbell 2.

3. Slide the door chime to OFF when you don’t want to hear it ring.

ON/OFF.

Add Another Alarm

You can expand your doorbells to sound an additional alarm. To do this, you will need to wire one or both doorbells to an alarm that contains a normally open contact.

1. Connect both tips of a 2-conductor wire (not supplied) to a doorbell, as shown, using two M3 screws.

2. Connect both tips of the other end of the 2-conductor wire to the extra alarm.

Now, when you press your doorbell, both the door chime and the alarm will sound.

Speciﬁcations

Frequency .............................................. 433.92 MHz ± 600 KHz

Doorbell current consumption .....................................<10 mA

Chime current consumption ........................ <2 mA @ standby

........................................................................<130 mA @ chime

Chime battery low ................................................. 2.4 V ± 0.1 V

Chime audio power .......................... > 80 dBA @ 10 in (25 cm)

Doorbell operating temperature.......................–4° F to 140° F

...........................................................................(–20° C to 60° C)

Speciﬁcations are subject to change and improvement without notice. Actual product may vary from the images found in this document.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult your local RadioShack store or an experienced radio/TV technician for help.

If you cannot eliminate the interference, the FCC requires that you stop using your equipment. Changes or modiﬁcations not expressly approved by RadioShack may cause interference and void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Limited Warranty

RadioShack warrants this product against defects in materials and workmanship under normal use by the original purchaser for ninety (90) days after the date of purchase from a RadioShack-owned store or an authorized RadioShack franchisee or dealer. RADIOSHACK MAKES NO OTHER EXPRESS WARRANTIES.

This warranty does not cover: (a) damage or failure caused by or attributable to abuse, misuse, failure to follow instructions, improper installation or maintenance, alteration, accident, Acts of God (such as ﬂoods or lightning), or excess voltage or current; (b) improper or incorrectly performed repairs by persons who are not a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) ordinary wear and tear or cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs of product removal, installation, set-up service, adjustment or reinstallation; and (g) claims by persons other than the original purchaser.

Should a problem occur that is covered by this warranty, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store in the U.S. RadioShack will, at its option, unless otherwise provided by law: (a) repair the product without charge for parts and labor; (b) replace the product with the same or a comparable product; or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period.

RADIOSHACK EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON THE EXPIRATION OF THE STATED WARRANTY PERIOD.

EXCEPT AS DESCRIBED ABOVE, RADIOSHACK SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RADIOSHACK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you speciﬁc legal rights, and you may also have other rights which vary from state to state. You may contact RadioShack at: RadioShack Customer Relations 300 RadioShack Circle, Fort Worth, TX 76102 04/08

www.RadioShack.com

Protect the environment by recyling used electronics. Go to E-CyclingCentral.com to ﬁnd an electronic recycling center near you.

Printed in China

02B11

61-140

2/2

2 3 4 5 6 7 8