Radio Shack 120362 User Manual

©2007. RadioShack Corporation. All rights reserved. Accurian is a registered trademark used by RadioShack Corporation.
This product is not designed, manufactured, sponsored, or endorsed by Apple Computer, Inc. iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.

12-362

09A06

P/N: AO0294AAA1

Printed in China

Thank you for purchasing your FM transmitter
from RadioShack. Please read this user’s guide
before installing, setting up, or using your new FM
transmitter.

What’s Included

FM Transmitter USB Cable
User’s Guide

Specications

Audio input .................................30-pin connector from iPod

Transmitting freq. ............ 88.1-107.9 MHz with 0.2 MHz step

Modulation ................................................................ FM stereo

Operating range ...................................................... 10 - 30 feet

Specications are subject to change and improvement

without notice. Actual product may vary from the images
found in this document.

RF Emissions

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.
Consult your local RadioShack store or an experienced radio/TV
technician for help.
If you cannot eliminate the interference, the FCC requires that you

stop using your equipment. Changes or modications not expressly

approved by RadioShack may cause interference and void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation

is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause
undesired operation.

Limited 90-Day Warranty

This product is warranted by RadioShack against manufacturing
defects in material and workmanship under normal use for ninety
(90) days from the date of purchase from authorized RadioShack
dealers. For complete warranty details and exclusions, check with
your dealer or contact RadioShack directly.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102 04/04

12-362

FM Transmitter

IMPORTANT SAFETY INFORMATION

Connect and operate this product BEFORE operating your
vehicle and pay attention to the road. Attempting to drive
and scan your set at the same time can cause a serious

trafc accident! Drive responsibly.

Step 1: Connect the Transmitter

Plug the FM transmitter into the iPod dock connector and
begin playing music, the FM transmitter powers on and
displays the last used frequency.

To change the frequency, press or .

Note: If your FM transmitter does not power on after
connecting to the iPod, press § on your iPod twice.

Step 2: Tune Your Radio

Tune your FM radio to the frequency displayed on the
transmitter.

Step 3: Listen to Your Music

To listen to your music, use the volume controls on the radio

to adjust the volume.

Note: The volume control on your iPod does not control the
sound on the radio.

Connect to your iPod

Saving Frequencies

1. Press or to tune the desired frequency.

2. Press and hold M until M1 ashes.

3. To save a frequency in M2, press or to select M2
and hold M to store the memory location. Then, tune
a frequency and Press and holdPress and hold M until M2 ashes.

Selecting a Saved Frequency

1. Press M once for M1, M1 and its frequency appear.

2. Press M again for M2, M2 and its frequency appear.

To charge your iPod,
connect the supplied USB
cable to the transmitter
and to your computer.