Universal Equipment
Wall Mount
Patent(s) Pending
Installation Instructions
Kit P/N: 104-2109
104-4010
Kit Contents
Assembly Components:
(1) Wall Bracket
(1) Clamp Bracket
(2) Adjustment Knobs
Wall Mount Hardware Package:
(4) Pan Head Screws
(4) Anchors
Wall Mount Installation Instructions
Step 1. Determine Location: Select appropriate location on wall. Consider cable routing
and length.
Step 2. Mark Hole Positions: Hold Wall Bracket in position and mark 4 hole positions
with pencil.
Step 3a. Install Drywall Anchor: Install one drywall anchor at each hole mark. Using a
#2 Phillips head screwdriver press the anchor into the drywall while turning
clockwise until it is seated ush with the wall.
Step 3b. Install 4 Screws: Leave 1/4" of each screw out of wall.
1/4"
Page 2
Installation Instructions
Step 4. Attach Wall Bracket: Attach Wall Bracket to wall using the 4 screws that were
installed in 3b. Tighten Securely.
Step 5. Install Clamp Bracket: Slide Clamp Bracket onto the Wall Bracket then install
the Adjustment Knobs as shown. Pull Clamp Bracket out from the wall as far as
possible. Do not tighten the Adjustment Knobs at this time.
Wall Bracket
Clamp
Bracket
(2) Adjustment Knobs
Page 3
Installation Instructions
Step 6. Install Equipment: Slide equipment into Bracket Assembly as shown. See table
below for minimum and maximum equipment widths.
Equipment
Bracket Assembly
P/N Minimum Maximum
104-2109 2.35" 4.00"
104-4010 4.00" 8.00"
Step 7. Secure Equipment: Push Clamp Bracket rmly against the equipment, then fully
tighten Adjustment Knobs.
Warranty Statement
Innovation First, Inc. warrants our products against defects in material and workmanship for a
period of one (1) year from the date of purchase. Innovation First, Inc. liability shall be limited to
repairing or replacing, at our option, any defective product.
2109 4010
Loading...