Racing Electronics SWITCH User Manual

Avoid Hearing Damage

To prevent possible hearing damage, do not use the SWITCH at high volume for a long period of time
and always lower the volume level of the device you connect to the SWITCH Audio Input port before
connecting.

WZ5-SWITCH

FCC ID:

Model : SWITCH and SWITCH RACER.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may
cause undesired operation.

WARNING:
Modification of this device to receive cellular radio telephone service signals is prohibited under FCC
rules and Federal Law.

The complete declaration is available online at: www.racingelectronics.com

www.RacingElectronics.com

1-800-272-7111

8 9 10 11 12

13
14

1

Power On/Off Button

2

Volume or Channel Up/Down Buttons

3

Programming Button

4

Channel 1 Preset Button

5

Channel 2 Preset Button

6

Scanning modes Button

7

IN (Auxiliary Audio Input), OUT (Earphone Jack)

8

Channel or Sub Channel Indicator

9

Channel Number Display

10

Volume Level Bars

11

Communication Indicator

12

Low Battery Indicator

13

Frequency Display

14

Preset or Scan Mode Selection Indicator

1

2

7

34 5 6

OPERATION MODES PROGRAMMING STEPS

1

Channel 1 Preset Listening

1

Press to hold on the preset 1
channel.
Long press to display the preset 1
sub channel info on the display.

1

Channel 2 Preset Listening

2

Press to hold on the preset 2
channel.
Long press to display the preset 2
sub channel info on the display.

2

Scanning

SCAN

Press to scan between
Preset 1 and 2.

CH

193

452.4000

1

CH

321

454.0000

2

CH

800

454.0000

SCAN

Channel Programming

Long Press on the Prog .
The channel number is blinking.

2

Navigate through the
Channels

Scroll up or down with
to select a channel.
Long press to skip up by 100.
Press Prog for sub channel
programming or long press on

2

or to save the frequency as a
preset 1 or 2.

3

Navigate through the
Sub Channels

Scroll up or down with
to select a sub channel.
Long press to skip up by 10.

454.0000

1

454.0000

1

SUB

454.0000

Note: OFF = Not Considered

CH

800

CH

800

CH

OFF

Prog

2

Prog

Scanning with Priority

SCAN

Hold and then press or
at the same time to set the preset 1 or 2
as a priority on the scanning process.
The preset 1 or 2 selection indicator
is blinking when the priority is set.

1

2

CH

800

454.0000

1

SCAN

4

Save Channel and
Exit Programming Mode

1

Long Press on or to save
the frequency as a Preset 1 or 2.
Exit programming mode by
pressing the Prog .

2

SUB

CH

023

454.0000

1

2

Prog