Page 1
VXLED13DG INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fi xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com
IMPORTANT
READ CAREFULL Y BEFORE INST ALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable
parts inside.
CEILING MOUNT
Fixture must be ceiling mounted. Use a recessed or
surface mount junction box (not supplied) or use the
Housing to make electrical connections. Fixture cannot
be mounted upside down in wet locations!
1. Loosen Housing Screws and open Housing.
2. Prepare back of Housing to use by knocking out
necessary mounting holes.
3. Seal all gaps between ceiling and fi xture with
weatherproof silicone sealant.
4. Fixture may be wired through back conduit entrance
or side conduit entrance for surface mounting.
5. Connect wires as shown in wiring section.
6. Close Housing. Tighten screws and check Housing
Gasket seal.
7. Seal all holes, plugs and conduit entrances with
weatherproof silicone sealant.
Housing
Housing
Gasket
Housing
Screws
Pat. Pending
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
Page 2
VXLED13DG INSTALLATION INSTRUCTIONS
WIRING
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz.
1. Connect the black fi xture lead to the (+) LINE
supply lead.
2. Connect the white fi xture lead to the (-) COMMON
supply lead.
3. Connect the GROUND wire from fi xture to
supply ground.
-*/& #-"$,
$0..0/ 8)*5&
(306/%
(306/%
-*()5
'*9563&
CLEANING & MAINTENANCE
CAUTION: Be sure fi xture temperature is cool
enough to touch. Do not clean or maintain while
fi xture is energized.
1. Clean glass lens & fi xture with non-abrasive glass
cleaning solution.
2. Do not open fi xture to clean the LED. Do not touch
the LED.
TROUBLESHOOTING
1. Check that the line voltage at fi xture is correct.
2. Is there voltage at the lamp fi xture wires? If there is
no voltage, check all connections.
3. Is the fi xture is grounded properly?
VXLED13DG-IN-0211
Loading...