RAB Lighting LFLED Series, LFLED5 Cool, LFLED5 Neutral, LFLED5 Warm Installation Instructions Manual
Page 1
LFLED INSTALLATION INSTRUCTIONS
LF Flood LF Spot
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: marketin g@r abweb.c om
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable
parts inside.
WALL MOUNTING
Mount to a weatherproof junction box and cover plate
(not supplied) as shown. To ensure weatherproof seal,
apply weatherproof silicone sealant around the edge of
the wall cover plate or surface box. This is especially
important with an uneven wall surface.
1. Seal arm thread using Teon tape or silicone sealant.
2. Thread xture into Cover Plate(not supplied).
3. Connect wires as shown in the wiring diagram.
4. Attach cover plate to Junction Box (not supplied).
5. Aim oodlight in the direction desired and tighten
locknut and Arm Screw.
Arm Screw
GROUND MOUNTING
Mount to a Mighty Post (RAB Cat# MP19) as shown.
1. Thread xture into Mighty Post Cap.
2. Connect wires as shown in the wiring diagram and
place inside the Mighty Post.
3. Place Mighty Post Cap on the Mighty Post.
4. Aim oodlight in the direction desired and tighten
locknut and Arm Screw.
Arm Screw
Mighty Post
Cap
Junction Box
(not supplied)
Cover Plate
(not supplied)
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
Mighty Post
Page 2
LFLED INSTALLATION INSTRUCTIONS
WIRING
Universal voltage driver permits operation at 120V thru
240V, 50 or 60 Hz.
1. Connect the black xture lead to the (+) LINE
supply lead.
2. Connect the white xture lead to the (-) COMMON
supply lead.
3. Connect the GROUND wire from xture to
supply ground.
TROUBLESHOOTING
1. Check that the line voltage at xture is correct.
2. Is there voltage at the lamp xture wires? If there is
no voltage, check all connections.
3. Is the xture grounded properly?
CLEANING & MAINTENANCE
CAUTION: Be sure xture temperature is cool
enough to touch. Do not clean or maintain while
xture is energized.
1. Clean glass lens & xture with non-abrasive glass
cleaning solution.
2. Do not open xture to clean the LED. Do not touch
the LED.
3. Keep leaves and debris out of hood.
LFLED5 Cool
LFLED5 Neutral
LFLED5 Warm
LFLED-IN-0613
Loading...