Page 1
HSLED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
WALL MOUNTING
Mount to a weatherproof junction box and cover plate (not
supplied) as shown. To ensure weatherproof seal, apply
weatherproof silicone sealant back of junction box. This is
especially important with an uneven wall surface.
1. Thread xture into Cover Plate. Seal arm thread using
teon tape or silicone sealant.
2. Connect wires as shown in the wiring diagram
3. Attach cover to Junction Box.
4. Aim oodlight in the direction desired and tighten
locknut and Arm Screw.
5. Be sure the Weep Hole on hood is oriented such that it
does not allow accumulation of water.
Junction Box
Cover Plate
GROUND MOUNTING
Mount to a Mighty Post(RAB Cat# MP19) as shown.
1. Thread xture into Mighty Post Cap.
2. Connect wires as shown in the wiring diagram and place
inside the Mighty Post.
3. Place Mighty Post Cap on the Mighty Post.
4. Aim oodlight in the direction desired and tighten locknut
and Arm Screw.
5. Be sure the Weep Hole on hood is oriented such that it
does not allow accumulation of water.
Weep Hole
Arm Screw
Mighty
Post Cap
Arm Screw
Weep Hole
Note: These instructions do not cover all details or variations in
equipment nor do they provide for every possible situation during
installation, operation or maintenance.
Mighty Post
Page 2
HSLED INSTALLATION INSTRUCTIONS
Easy Installation & Product Help
©2012 RAB LIGHTING Inc.
No
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
WIRING
Universal voltage driver permits operation at 120V through
277V, 50 or 60 Hz.
1. Connect the black xture lead to the (+) LINE supply lead.
2. Connect the white xture lead to the (-) COMMON supply
lead.
3. Connect the GROUND wire from xture to supply ground.
TROUBLESHOOTING
1. Check that the line voltage at xture is correct.
2. Is there voltage at the lamp xture wires? If there is no
voltage, check all connections.
3. Is the xture grounded properly?
4. If there is a photocell, is it working properly?
CLEANING & MAINTENANCE
CAUTION: Be sure xture temperature is cool enough to
touch. Do not clean or maintain while xture is energized.
1. Clean glass lens & xture with non-abrasive glass cleaning
solution.
2. Do not open xture to clean the LED. Do not touch the
LED.
3. Keep leaves and debris out of hood.
HSLED13 HSLED13N HSLED13Y
rthvale, New Jersey 07647 USA
HSLED-IN-1212
Tech Help Line
Call our experts 888 RAB-1000
rabweb.com
Visit our website for product info
email
Answered promptly sales@rabweb.com
Loading...