Page 1
FFLED39 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000, or email: marketin g@rab web. com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. For xtures weighing more than 10lbs: Do not mount to an outlet cover unless a
separate splice box is used. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable
parts inside.
LOCATION
1. Seal arm thread using teon tape or silicone sealant.
2. Secure the LED Flood to a 1/2” NPS hole in a
junction box or landscape post.
3. Plug all unused holes and seal threads with silicone.
4. The swivel arm on the LED Flood allows 180º of
vertical aiming adjustment depending on mounting
location.
WIRING
Universal voltage drivers permit operation at 120V to
277VAC, 50 or 60 Hz except xtures factory ordered
with a 120V photocell (/PC)
1. Connect the BLACK xture lead to the
(+) LINE supply lead.
2. Connect the WHITE xture lead to the
(-) COMMON supply lead.
3. Connect the bare copper Ground wire from xture
to supply ground.
GUARD OR SHIELD INST ALLA TION
Wire Guard and Poly Shield mount with (4) #8-32
Stainless Steel Screws. Screws are provided with
accessory. See gure 1 for Guard. See gure 2
for Shield
1. Line up guard with pre-existing, pre-drilled holes in
frame as shown, tighten screws.
Figure 1
Stainless
Steel
Screws
Figure 2
Stainless
Steel
Screws
GUARD & SHIELD INSTALLATION
The Wire Guard and Poly Shield can be mounted on the
same xture with (4) #8-32 screws as shown below.
Page 2
FFLED39 INSTALLATION INSTRUCTIONS
TROUBLESHOOTING
1. Check that the line voltage at the xture is correct.
Refer to wiring directions.
2. Is the xture grounded properly?
3. Is the photocell, if used, functioning properly?
ACCESSORIES AND
REPLACEMENT PARTS
Chrome Wire Guard: GDFFLED39W
Poly Shield:
Lens & Door Replacement: LFFLED39 (bronze)
LFFLED39W (white)
FFLED39 Cool
GDFFLED39P
FFLED39N Neutral FFLED39Y Warm
CLEANING & MAINTENANCE
CAUTION: Be sure xture temperature is cool
enough to touch. Do not clean or maintain while
xture is energized.
1. Clean glass lens with non-abrasive glass cleaning
solution.
2. Do not open the xture to clean the LED. Do not
touch the LED.
US:Pat D643,147, CA: Pat Pending CN: Pat Pending,
MX: Pat Pending
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
FFLED39-IN-1011
Loading...