Rabbit Air BioGS 2.0 Quick Start Manual
Quick Start Guide
Let’s Begin!
BioGS 2.0 initial filter installation
Complete these steps first before operating the unit.
Front panel
Start Here
1. Remove the front
panel by lifting from the
bottom and pulling up.
Pre-Filter
Charcoal-Based
Activated Carbon
Filter
2. Pinch the two tabs on
top of the Pre-Filter to
remove it.
BioGS HEPA
Filter
4. Remove the HEPA Filter and
discard its plastic wrapping.
3. Pull out the Activated Carbon Filter
and discard its plastic wrapping.
24/7 customer care
For questions, call 888.866.8862
Visit us at www.rabbitair.com
Next Page
Finishing up!
Complete these steps first before operating the unit.
5. Return the filters to the filter case in the following
order from back to front:
BioGS HEPA Filter
Activated Carbon Filter
Pre-Filter
6. Reattach the front panel.
Meet the User Interface
Device Control
(See page 8 in the manual)
Tap to power on and change mode
Press & hold to power off
Filter Status
(See page 11 & 12 in the manual)
Filter Maintenance Indicator
On: Clean Filters
Flashing: Replace Filters
New Filters
15 Months
12 Months
9 Months
6 Months
3 Months
Filter Maintenance Indicator
Press to turn off
Press & hold to reset
Filter Life Indicator
Filter Life Indicator
Device Settings
(See page 9 & 10 in the manual)
Air Quality
Pollutant level
Fan Speed
Auto Mode
Sensitivity level
Sleep Timer
Negative Ions
Low • • • High
Low • • • High
Low Med High
4hr 8hr 12hr
On/Off
• Air Quality Indicator
The Air Quality readings are
based on both odor and
particle levels in the air.
• Fan Speed
Indicates the current fan
speed of the unit.
• Auto Mode
Indicates the sensitivity of the
air quality sensors. The fan will
automatically adjust its speed.
• Timer
Set the air purifier to turn off
after 4, 8, or 12 hours.
The filter maintenance and replacement light
will illuminate based on how often and which
speed you operate your air purifier on. Based
on an algorithm that calculates the amount of
airflow and run time, your filter replacement
indicator will illuminate between 6 to 24
months. Your filter cleaning indicator will
illuminate between every 4 to 18 weeks.
This feature can be accessed
through the main control
button.
This feature can be accessed
through the remote.
• Negative Ions
Turn the Negative Ion
Generator on or off.
©2019 Rabbit Air. All rights reserved. BioGSQS1909
Loading...