QwikClean B2278209 User Manual

NOTICE: This PDF includes a separate SDS representing each

of the component parts of a 2-Part Kit. Each SDS includes 4 sequential
pages of pertinent content.

QwikSeal™ AC/R Leak Sealant with Drying Agent
Is a 2-Part Kit involving separate 0.5 oz. bottles (labeled Part A and

Part B respectively).
Part A – Drying Agent

(actual PDF combined document pages 2-5)
Part B – Leak Sealant

(actual PDF combined document pages 6-9)

200 Yellow Place  Rockledge, FL 32955

REVISION DATE: 02/24/2017

SECTION 1 - PRODUCT & COMPANY IDENTIFICATION

SECTION 2 - HAZARDS IDENTIFICATION

SECTION 3 - PRODUCT COMPOSITION INFORMATION

SECTION 4 - EMERGENCY & FIRST-AID PROCEDURES

PH: [phone]  FAX: [phone]

E-mail: [e-mail]

S A F E T Y D A T A S H E E T

P264 Wash exposed skin thoroughly after handling.
P280 Wear protective gloves/protective clothing/eye

protection/face protection.

PRODUCT NAME: QwikSeal® Part A
USE: Drying agent for HVAC/R Systems
DESCRIPTION: Clear liquid, characteristic odor

MANUFACTURER: Mainstream Engineering Corporation

200 Yellow Place
Rockledge, Florida 32955

INFORMATION TELEPHONE: [phone]
EMERGENCY TELEPHONE: [phone]

GHS CLASSIFICATION IN ACCORDANCE WITH 29 CFR 1910

(OSHA HCS): Flammable liquids (Category 3); Skin

sensitization (Category 1B); Eye irritation (Category 2B);
Reproductive toxicity (Category 2)

HAZARD STATEMENT(S):

H226 Flammable liquid and vapor
H320 Causes eye irritation
H361 Suspected of damaging fertility or unborn child

PICTOGRAM(S):

SIGNAL WORD: Warning

PRECAUTIONARY STATEMENT(S):

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have

been read and understood.

P210 Keep away from heat/sparks/open flames/hot

surfaces. - No smoking.
P233 Keep container tightly closed.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static

discharge.
P261 Avoid breathing dust, fumes, gas, mist, vapors,

and/or spray.

P303 + P361 + P353
IF ON SKIN (or hair): Remove immediately all

contaminated clothing. Rinse skin with water.
P305 + P351 + P338
IF IN EYES: Rinse cautiously with water for several

minutes. Remove contact lenses, if present and

easy to do. Continue rinsing.
P308 + P313
If exposed or concerned: Get medical advice.
P337 + P313
If eye irritation persists: Get medical advice.
P370 + P378
In case of fire: Use carbon dioxide, dry sand, dry

chemical or alcohol-resistant foam for extinction.
P403 + P235
Store in a well-ventilated place. Keep cool.
P501 Dispose of contents/ container to an approved

waste disposal plant.

HAZARDS NOT OTHERWISE CLASSIFIED BY GHS: none

COMPONENT CAS # AMOUNT

2,2-Dimethoxypropane 77-76-9 40-80%
* 20-60%

* TRADE SECRET – PATENT PENDING PROPRIETARY
FORMULA. Specific chemical identities are withheld as a
trade secret under the provisions of OSHA hazard
communication standard 29 CFR 1910.1200

EYE: Flush eyes gently with water for at least 15 minutes

while holding eyelids apart; seek immediate medical
attention.

SKIN: Remove contaminated clothing. Wash exposed area

with soap and water. If symptoms persist, seek medical
attention.

INGESTION: Seek medical attention. If individual is drowsy

or unconscious, do not give anything by mouth; place
individual on the left side with the head down. Contact a
physician, medical facility, or poison control center for

Page 1 of 4

200 Yellow Place  Rockledge, FL 32955

SECTION 5 – FIRE-FIGHTING MEASURES

SECTION 6 – ACCIDENTAL RELEASE MEASURES

SECTION 7 – HANDLING AND STORAGE

SECTION 8 – EXPOSURE CONTROLS AND PERSONAL

PROTECTION MEASURES

PH: [phone]  FAX: [phone]

E-mail: [e-mail]

advice about whether to induce vomiting. If possible, do
not leave individual unattended.

INHALATION: If symptoms develop, immediately move

individual away from exposure and into fresh air. Seek
immediate medical attention. Keep person warm and
quiet. If person is not breathing, begin artificial
respiration. If breathing is difficult, administer oxygen.

EXTINGUISHING MEDIA: Use dry chemical, carbon dioxide,

or foam extinguishing materials.

HAZARDOUS DECOMPOSITION PRODUCTS: Carbon

dioxide, carbon monoxide, silicon oxides.

UNUSUAL FIRE AND EXPLOSION HAZARDS: Material is

volatile and readily gives off vapors which may travel
along the ground or be moved by ventilation and ignited
by pilot lights, flames, sparks, heaters, smoking, electric
motors, static discharge or other ignition sources at
locations near the material handling point.

SPECIAL FIRE FIGHTING PROCEDURES: Wear self-

contained breathing apparatus in positive pressure mode
with confined facepiece.

PERSONAL PRECAUTIONS, PROTECTIVE EQUIPMENT AND

EMERGENCY PROCEDURES: Use personal protective

equipment outlined in section 8 for normal handling of
this material. Remove all possible sources of ignition
from the vicinity. Ensure adequate ventilation and
minimize exposure to vapors. Evacuate personnel to safe
areas. For personal protection see section 8.

ENVIRONMENTAL PRECAUTIONS: Prevent release to the

environment if possible. Do not flush product into drains
or sewer lines.

MATERIALS FOR CONTAINMENT AND CLEAN-UP: Use a

nonflammable absorbent material for clean-up. Place in
container for disposal according to local regulations.

REFERENCE TO OTHER SECTIONS: For additional disposal

directions and reporting requirements, please refer to
Section 13.

PRECAUTIONS FOR SAFE HANDLING: Keep container

closed when not in use. Use good personal hygiene
practices in accordance with this material. Avoid getting
the product in eyes or on skin. Remove contaminated
clothing and clean before re-use. Wash hands before
eating or drinking.

Make sure there is adequate ventilation in order to
minimize exposure to possible vapors.

Keep away from heat and flame. Keep operating
temperatures of equipment below ignition temperatures
at all times. Use non-sparking tools.

Please wear appropriate personal protective equipment
for handling of this product as outlined in Section 8.

STORAGE: Store in a cool, dry location. Keep container

tightly closed. Do not store near heat, flame, strong

oxidants. Maintain adequate ventilation.

SPECIAL STORAGE CONSIDERATIONS: Even when emptied,

the containers may retain product residues (vapor
and/or liquid), and this may pose a static ignition hazard.

Sudden release of hot organic vapors or mists from
process equipment operating at elevated temperature
and pressure, or sudden ingress of air into vacuum
equipment, may result in ignition without presence of
obvious ignition sources. Any use of this product in
elevated temperature processes should be thoroughly
evaluated to establish and maintain safe operating
conditions.

EXPOSURE LIMITS: No exposure limits have been

established for this material.

ENGINEERING CONTROLS: In enclosed environments,

exhaust ventilation by explosion-proof mechanical
means may be necessary to control air contaminants
below specified exposure limits. Handle product in
accordance with good industrial hygiene and safety
practice.

PERSONAL PROTECTIVE EQUIPMENT: Please wear

appropriate person protective equipment for handling of
this product as indicated below.

EYE PROTECTION: Chemical splash goggles are advised.
SKIN PROTECTION: Use gloves of an appropriate material

(latex, nitrile or PVC gloves) to minimize exposure.

RESPIRATORY PROTECTION: Engineering or administrative

controls should be implemented to reduce exposure
during normal handling of this product. If the workplace

Page 2 of 4