© Copyright Qvis® All documentation rights reserved
Door and window contact
DOOR-CONTACT1
User’s Manual
V2.0 06 / 2014
© Copyright Qvis® All documentation rights reserved
1. FEATURES
Ultra-thin modern design, suitable for various kinds of doors and
windows.
Shell buckling design for convenient battery changing. Lithium Battery
lasts for over 2 years.
Tamper Alarm Function.
Manual alarm button can be used as emergency button.
Low power alert function (the correspondent control panel supports this)
2. DIAGRAM
KEY:
1
LED indication
2
Coding Button
Alarm Button
3
Transmitter
4
Magnetic Bar
5
Reed Switch
6
Lithium Battery
7
Crystal Oscillator
8
Tamper Alarm Switch
Set the alarm control console to coding status (please refer to the alarm
console manual), then trigger the door sensor (by separating the magnetic bar
and transmitter) or press the coding button. The door sensor will send wireless
signal to the panel for coding
.
After successful coding, install the door sensor to the door/window.
1 2 3
5 4 6
7
8
Internal
Diagram
© Copyright Qvis® All documentation rights reserved
3. SPECIFICATIONS
Working voltage
DC 6V (2pcs CR2032 Li Battery)
Alarm current
<30mA (Standby: <5uA)
Emitting Code
1527
Working Temperature
+10~+40℃
Humidity
≤95%
Emitting frequency
433+0.5MHz (Emitting power: 25dbm)
Emitting distance
With exterior soft antenna: no
obstacle 70M
4. INSTALLATION
This door sensor consists of one magnetic bar and one transmitter which are
fixed on the door frame (window frame) respectively by double-side adhesive
tape or screws.
IMPORTANT:
Transmitter should be installed parallel with magnetic bar. Keep them as
close as possible to a distance less than 10mm. Please install on the
magnetic bar on the right hand side of the transmitter.
It is recommended to use screws or glass cement for firm installation.
The gap between the magnetic bar and transmitter should not exceed
10mm. Install the magnetic bar to the right side of the transmitter. Only
when there is a certain gap between them, the door sensor will send
alarm signal.
Open the door/window, if the indicator on transmitter flashes red, it
means the door sensor is working normally.
10mm
© Copyright Qvis® All documentation rights reserved
5. LOW BATTERY POWER INDICATION
When the red indicator on the emitting box lights on, it means the battery is
in low power status. Please change battery in time to avoid alarm failure.
6. WORKING STATUS
Alarm Type
How to trigger alarm
Door contact
performance
SOS alarm
Press SOS button
This will send an alarm
signal to the control
panel. The red LED will
be on when signal is
being sent. It will turn off
when signal has been
sent.
Door alarm
The magnetic bar and
the transmitter are
separated with a
distance of over 15mm.
Tamper alarm
Open the back cover
This will send an alarm
signal like in the
description above. It will
then send a low power
signal to the control
panel. The red LED will
flash during the signal
sending process.
Low power alarm
The battery power is
less than 5V.
© Copyright Qvis® All documentation rights reserved
For more information about our DVRs and available cameras & accessories,
please visit our website:
www.adata.co.uk
Alternatively scan this QR code with your smart phone to be directed instantly
to our website:
Loading...