BulbRecommended: (5) CandelabraBase60W Maximum
EstimatedAssemblyTime:20-30 minutes
Preparation:Identify and inspectallparts before beginninginstallation.Check package
contentlist and diagramsbelowto be sureallparts are present.Ifany parts aremissing
ordamaged, do notattemptto assemble, install,oroperate the fixture.Contactcustomer
servicefor replacement parts.
Assembly Instruction Sheet #IS-WSY5005IF
For Style WSY5005IF
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
Part
ACrossbar
B
C
D
E
F
G
H
I
J
K
L
M
N
O
Description
Nipple
Lock Washer
Hex Nut
Ceiling Canopy
Canopy Chain Loop
Canopy Lock Ring
Fixture Chain
Fixture Body
Fixture Loop
Nipple with Hex Nut
Knurled Nut
Support Part
Cap
Finial
Quantity
1pc.
1pc.
2 pcs.
2 pcs.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
2 pcs.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
Thank youfor purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.September2012
or visit us on-line at www.quoizel.com
1of7
WSY5005IF
FINISH: ITALIAN FRESCO
QUIOZEL
GND
2.4 m m 13 G a
2
5.5” Dia.
1"
Overall Height 125.5”
(Includes 96” Chain)
1
27”
(5) 60W Candelabra
Base Bulbs
(No Supplied)
PART NUMBER
NO.
1
15005IFWSY
2
M2375CHIF
3
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
BASEWSY5005IFITALIAN FRESCO
CHAIN3.8MM X 4’ITALIAN FRESCO
26” Dia.
REQ.
1
1
2of7
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY5005IF
For Style WSY5005IF
STEP 1Adjust Fixture Assembly-
A. Unfold support arms on fixture assembly to proper
locations. Thread the Lock Ball secure the side arms,
hand tighten until snug.
STEP 2 - Attach Fixture Loop Assembly to
Fixture Body
A. Thread Fixture Loop (I) to the Nipple on the Fixture
Body (J). Hand tighten until snug.
Lock Ball
Fixture Loop
Figure 1
Figure 2
Nipple
Fixture
Body
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.September2012
or visit us on-line at www.quoizel.com
3of7
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY5005IF
For Style WSY5005IF
STEP 3 - Attach Support Part and Cap to
Fixture Body
A. Pass the Nipple with Hex Nut (K) through the center
hole on the bottom of Fixture Body (J), thread Knurled
Nut (L) onto the Nipple, hand tighten until snug. Thread
one Finial (O) onto the Nipple, hand tighten until snug.
B. Place Support Part (M) and Cap (N) onto the Nipple then
thread another Finial (O) onto the Nipple. Hand tighten
until snug.
Finial
Knurled Nut
Nipple with Hex Nut
Support Part
Cap
STEP 4 - Attach Crossbar to Outlet Box
A. Secure the Crossbar (A) to the outlet box with outlet
box screws (not supplied). Tighten until snug.
STEP 5Attach Nipple to Crossbar-
A. Thread one Hex Nut (D) onto the top end of the Nipple
(B).
B. Place one Lock Washer (C) over the top end of the
Nipple (B) and then thread the Nipple (B) into the center
lock hole of the Crossbar (A).
C. Using pliers, thread the hex Nut (D) against the
Crossbar (A) and hand tighten until snug.
Figure 4
Mounting
Hole
Finial
Crossbar
Lock Washer
Hex Nut
Figure 3
Outlet Box
Crossbar
Outlet Box
Screw (not
Supplied)
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of7
Nipple
Figure 5
September2012
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY5005IF
For Style WSY5005IF
STEP 6 - Attach Canopy Chain Loop to Nipple
A. Thread another Hex Nut (D) onto the end of the Nipple
(B).
B. Place the Lock Washer (C) over the end of the Nipple
(B) and then thread the Canopy Chain Loop (F) onto the
end of the Nipple (B).
C. Using pliers, thread the Hex Nut (D) against the
Canopy Chain Loop (F) and hand tighten until snug.
STEP 7Assemble Ceiling Canopy-
A. Push the Ceiling Canopy (E) upward over the Outlet
Box. Thread the Canopy Lock Ring (G) onto the Canopy
Chain Loop (F) and tighten until snug to secure the
Ceiling Canopy (E).
Outlet Box
Nipple
Crossbar
Hex Nut
Lock Washer
Canopy
Chain Loop
Figure 6
Outlet Box
Canopy Chian Loop
STEP 8Attach Fixture Chain to Canopy
-
Chain Loop and Fixture Loop
A. Adjust the Fixture Chain (H) to your desired length by
removing the links if needed. You may need to use plier
to open the chain links. If so, put a cloth over the chain
to protect the finish from the pliers.
B. Attach one end of the Fixture Chain (H) onto the
Canopy Chain Loop (F) and then attach the other end of
the Fixture Chain (H) onto Fixture Loop (J).
Ceiling Canopy
Canopy
Lock Ring
Fixture Loop
Figure 7
Canopy Chain Loop
Fixture Chain
Supply Wire and
Ground Wire
Figure 8
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
5of7
September2012
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY5005IF
For Style WSY5005IF
STEP 9Pass Supply Wires through Fixture
-
Chain
A. Pull the Supply Wires and Ground Wire up through the
Fixture Chain (H) alternating links. Push the wires up
through the Canopy Chain Loop (F) into the outlet box.
STEP 10 - Make Wire Connections
A. Un-thread the Canopy Lock Ring (G) and slide Canopy Lock
Ring (G) and Ceiling Canopy (E) down the Fixture Chain (H).
B. Push all slack fixture wire through Canopy Chain Loop (F)
into Outlet Box. Trim excess fixture wire leaving a minimum
of 6 inch. Hanging out of the Outlet Box.
C. Use standard wire connectors to make all wire connections.
(Connectors are not included with fixture.) Strip and prepare
wire ends according to instructions supplied with connectors.
D. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
E. Connect Black (or Red) Supply Wire from the Outlet Box to
Black Wire from fixture.
F. Connect Ground Wire from the Outlet Box to Ground Wire
from fixture.
G. Twist connectors until wires are tightly joined together.
H. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
G. Re-attach the Ceiling Canopy (E) as shown in Step 5.
Supply Wire
and Ground
Wire from
Outlet Box
Canopy Chain
Loop
Fixture Chain
Supply Wire
and Ground Wire
Figure 9
Supply Wire and
Ground Wire
Canopy Chain Loop
Fixture Chain
Ceiling Canopy
Canopy Lock Ring
White wire from supplyWhite wire from fixture
Black wire from supply
(or Red)
Ground wire from supplyGround wire from fixture
Black wire from fixture
Figure 10
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
or visit us on-line at www.quoizel.com
6of7
Figure 11
September2012
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY5005IF
For Style WSY5005IF
STEP 11 - Install Bulb
A. This fixture uses standard bulbs with a standard screw
base. Maximum 60 watts.
B. Insert bulb and screw properly into place.
Your fixture is now assembled and ready to use.
Enjoy!
Figure 12
Bulb
Socket
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
7of7
September2012
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.