BulbRecommended: (4) Medium Base100WMaximum
EstimatedAssemblyTime:20-30 minutes
Preparation:Identify and inspectallparts before beginninginstallation.Check package
Customer Service
Phone 631.273.2700
Fax631.231.7102
contentlist and diagramsbelowto be sureallparts are present.Ifany parts aremissing
ordamaged, do notattemptto assemble, install,oroperate the fixture.Contactcustomer
servicefor replacement parts.
www.quoizel.com
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
Part
Description
ACrossbar
Nipple
B
Lock Washer
C
Hex Nut
D
Ceiling Canopy
E
Canopy Chain Loop
F
Canopy Lock Ring
G
H
Fixture Chain
Fixture Body
I
Stem
J
Fixture Body
K
Flat Washer
L
Rubber Washer
M
N
Shade
Cap
O
Cage
P
Finial
Q
Spacer
R
Check Ring
S
Quantity
1pc.
1pc.
2 pcs.
3 pcs.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
A
B
K
C
D
E
F
L
M
G
H
I
J
N
O
P
Q
R
S
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank youfor purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of7
October 2013
Page 2
WSY2820IF
FINISH: ITALIAN FRESCO
QUIOZEL
GND
2.4 m m 13 G a
5.5” Dia.
1”
Overall Height 123 5”
.
(Includes 96” Chain)
1
(4)100W
Medium Base Bulbs
(Not Supplied)
25”
6.5”
2
20” Dia.
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
PART NUMBER
NO.
1
M2375CHIFCHAIN ITLN FRSC 3.8MM X 4’1
REPLACEMENT PART DESCRIPTION
2G3638SHSHADE INDIA SCAVO 20"D1
2of7
REQ.
Page 3
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY2820IF
For Style WSY2820IF
STEP 1 - Attach Fixture Loop Assembly to
Fixture Body
A. Thread Fixture Loop (I) to Fixture Body (K). Tighten
until snug.
STEP 2 - Attach Crossbar to Outlet Box
A. Secure the Crossbar (A) to the outlet box with outlet
box screws (not supplied). Tighten until snug.
Mounting
Hole
Fixture Loop
Fixture
Body
Figure 1
Outlet Box
Crossbar
Outlet Box
Screw (not
Supplied)
STEP 3Attach Nipple to Crossbar-
A. Thread one Hex Nut (D) onto the top end of the Nipple
(B).
B. Place one Lock Washer (C) over the top end of the
Nipple (B) and then thread the Nipple (B) into the center
lock hole of the Crossbar (A).
C. Using pliers, thread the hex Nut (D) against the
Crossbar (A) and hand tighten until snug.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
or visit us on-line at www.quoizel.com
3of7
Figure 2
Crossbar
Lock Washer
Hex Nut
Nipple
Figure 3
October 2013
Page 4
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY2820IF
For Style WSY2820IF
STEP 4 - Attach Canopy Chain Loop to Nipple
A. Thread another Hex Nut (D) onto the end of the Nipple
(B).
B. Place the Lock Washer (C) over the end of the Nipple
(B) and then thread the Canopy Chain Loop (F) onto the
end of the Nipple (B).
C. Using pliers, thread the Hex Nut (D) against the
Canopy Chain Loop (F) and hand tighten until snug.
STEP 5Assemble Ceiling Canopy-
A. Push the Ceiling Canopy (E) upward over the Outlet
Box. Thread the Canopy Lock Ring (G) onto the Canopy
Chain Loop (F) and tighten until snug to secure the
Ceiling Canopy (E).
Outlet Box
Nipple
Crossbar
Hex Nut
Lock Washer
Canopy
Chain Loop
Figure 4
Outlet Box
Canopy Chian Loop
STEP 6Attach Fixture Chain to Canopy
-
Chain Loop and Fixture Loop
A. Adjust the Fixture Chain (H) to your desired length by
removing the links if needed. You may need to use plier
to open the chain links. If so, put a cloth over the chain
to protect the finish from the pliers.
B. Attach one end of the Fixture Chain (H) onto the
Canopy Chain Loop (F) and then attach the other end of
the Fixture Chain (H) onto the Fixture Loop on the top of
the Fixture Loop (I).
Ceiling Canopy
Canopy
Lock Ring
Fixture Loop
Figure 5
Canopy Chain Loop
Fixture Chain
Supply Wire and
Ground Wire
Figure 6
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of7
October 2013
Page 5
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY2820IF
For Style WSY2820IF
STEP 7Pass Supply Wires through Fixture
-
Chain
A. Pull the Supply Wires and Ground Wire up through the
Fixture Chain (H) alternating links. Push the wires up
through the Canopy Chain Loop (F) into the outlet box.
STEP 8 - Make Wire Connections
A. Un-thread the Canopy Lock Ring (G) and slide Canopy Lock
Ring (G) and Ceiling Canopy (E) down the Fixture Chain (H).
B. Push all slack fixture wire through Canopy Chain Loop (F)
into Outlet Box. Trim excess fixture wire leaving a minimum
of 7 inch. Hanging out of the Outlet Box.
C. Use standard wire connectors to make all wire connections.
(Connectors are not included with fixture.) Strip and prepare
wire ends according to instructions supplied with connectors.
D. Connect White Supply Wire from the Outlet Box to Ribbed
side Wire from fixture.
E. Connect Black (or Red) Supply Wire from the Outlet Box to
Smooth side Wire from fixture.
F. Connect Ground Wire from the Outlet Box to Ground Wire
from fixture.
G. Twist connectors until wires are tightly joined together.
H. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
I. Re-attach the Ceiling Canopy (E) as shown in Step 5.
Supply Wire
and Ground
Wire from
Outlet Box
Canopy Chain
Loop
Fixture Chain
Supply Wire
and Ground Wire
Figure 7
Supply Wire and
Ground Wire
Canopy Chain Loop
Fixture Chain
Ceiling Canopy
Canopy Lock Ring
White wire from supply
Black wire from supply
(or Red)
Ground wire from supplyGround wire from fixture
Ribbed side wire from fixture
Smooth side wire from fixture
Figure 9
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
or visit us on-line at www.quoizel.com
5of7
Figure 8
October 2013
Page 6
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY2820IF
STEP 9 - Attach Stem to Fixture Body
For Style WSY2820IF
A. Thread Stem (J) onto the Coupling on the Fixture Body
(K). Hand tighten until snug.
STEP 10 - Attach Shade to fixture
A. Place the Spacer (R), Check Ring (S), Cap (O), Shade
(N), Rubber Washer (M), and Flat Washer (L) over the
Stem (J) as shown, secure by thread the Hex Nut (D)
onto the Stem (J), hand tighten until snug.
Fixture Body
Coupling
Stem
Stem
Spacer
Check Ring
Cap
Figure 10
Figure 11
Shade
Rubber Washer
Flat Washer
Hex Nut
STEP 11Install Cage to Fixture-
Figure 12
A. Place the Cage (P) over the Stem (J) under side of the
Shade (N), secure by thread the Finial (Q) onto Stem (J),
hand tighten until sung.
Shade
Stem
Finial
Cage
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.October 2013
or visit us on-line at www.quoizel.com
6of7
Page 7
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-WSY2820IF
For Style WSY2820IF
STEP 12Install Bulb-
A. This fixture uses standard bulb with a standard screw base.
Maximum 100 watts.
B. Insert bulb and screw properly into place.
Your fixture is now assembled and ready to use.
Enjoy!
Figure 13
Socket
Bulb
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.October 2013
or visit us on-line at www.quoizel.com
7of7
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.