Quoizel TU8604BN User Manual
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
INSTRUCTION SHEET IS-TU8604
STYLE NUMBER: TU8604BN
PACKAGE CONTENTS
PART
A
B
C
D
E
F
G
H
DESCRIPTION
Mounting Screw
Socket Collar
Steel Collar
Bulb Shield
Bulb
Shade
Inner Backplate
Fixture Body
QUANTITY
4pcs
4pcs
4pcs
4pcs
4pcs
4pcs
1pc
1pc
ISSUED 08-2010
A
B
C
REVISED 2013-08-23
D
E
F
G
H
WARNINGS AND CAUTIONS
WARNING:
● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by switching
off the circuit breaker or removing the fuse.
CAUTION:
● These instructions are provided for your safety. It is very important that they are read completely before the
installation of your fixture. We strongly recommend that a professional electrician install the fixture.
● Disconnect fixture from the power source before replacing the bulb(s), making sure that bulb(s) had sufficient
time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may result.
PREPARATION
● Before beginning installation of product, make sure all parts are present. Compare parts with package contents
list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement part.
● Estimated Assembly Time: 20 - 30 minutes
● Tool Required for Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape,
Wire cutter, Safety glasses and (4) 60W Frosted G9 Halogen bulbs (supplied)
● Helpful Tools (not included): Wire strippers.
1OF3
.
INSTALLATION INSTRUCTIONS
STYLE NUMBER: TU8604BN
STEP 1:
a. Line up a set of holes on the Inner Backplate to the
mounting holes on the Outlet Box. With a pencil, point
two Marks on the wall surface from Keyholes.
b. Remove the Inner Backplate. Drill proper holes for Wall
Anchors and Outlet Box Screws.
c. Push the Wall Anchors into the drilled holes on the wall.
Place the Inner Backplate over the Outlet Box and
secure with (2) Outlet Box Screws and (2) Self-tapping
Screws.
STEP 2:
Use Wire Connectors (not supplied) to connect the
wires.
a. Connect the House Ground Wire to the Fixture Ground
Wire.
b. Connect the House White (or Ribbed) Wire to the
Fixture Supply Wire (Black or Smooth Side).
c. Connect the House Black (or Red) Wire to the Fixture
Supply Wire (Black or Smooth Side).
d. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
Outlet Box.
Wall Anchor
Outlet Box
Inner
Backplate
WHITE OR RIBBED
FROM HOUSE
BLACK (OR RED) WIRE
FROM HOUSE
GROUND WIRE
FROM HOUSE
Mark
Keyhole
Outlet Box Screw
Self-tapping Screw
WHITE OR RIBBED
FROM FIXTURE
BLACK OR SMOOTH
FROM FIXTURE
GROUND WIRE
FROM FIXTURE
STEP 3:
a. Place the Backplate over the Inner Backplate and
secure with Mounting Screws. Hand-tighten until snug
with screwdrivers.
Mounting Screw
Backplate
Inner Backplate
2OF3
Loading...