Page 1
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFLU2822K
For Style TFLU2822K
ToolsRequired:Flatheadscrewdriver,Phillips screwdriver,pliers,wirecutters, wire
Quoizel, Inc.
strippers,electricaltape,safetyglasses.
6 Corporate Parkway
Goose Creek, SC
29445
BulbRecommended: (4) Medium Base Maximum100W
EstimatedAssemblyTime:30-45 minutes
Preparation:Identifyandinspectallpartsbefore beginning installation. Check package
Customer Service
Phone 631.273.2700
Fax 631.231.7102
contentlistanddiagramsbelowto be sure all parts are present. If any parts are missing
ordamaged,donotattempttoassemble, install, or operate the fixture. Contact customer
serviceforreplacementparts.
www.quoizel.com
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of7
November2011
Page 2
TFLU2822K
FINISH: MYSTIC BLACK
6”
12”
2.4mm
13Ga
QUOIZEL
GND
R
2
8.5"
1"
57.5”
OVERALL HEIGHT INCLUDES
(4) 6” RODS AND (6)12” RODS
1
3
(4)100W A19
Medium Base Bulbs
(Not Supplied)
20.5"
5"
20" Dia.
21.5" Dia.
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
PART NUMBER
NO.
1
2
9012EXK
9006EXK
3 G2987SH
REPLACEMENT PART DESCRIPTION
ROD EXT MYSTIC BLACK 12"L X 0.5"D
ROD EXT MYSTIC BLACK 6"L X 0.5"D
SHADE TIFFANY BODY 20"D X 5"H
2of7
REQ.
6
4
1
Page 3
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFLU2822K
For Style TFLU2822K
Package Contents
Part
A Crossbar
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Description
Mounting Screw
Small Lock Washer
Small Hex Nut
Mounting Ball
6” Rod
12” Rod
Shade Holder
Ceiling Canopy
Flat Washer
Rubber Washer
Shade
Knurled Nut
Screw
Cross Part
Socket Assembly
Quantity
1pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
4 pcs.
6 pcs.
1pc.
1pc.
2 pcs.
2 pcs.
1pc.
2 pcs.
4 pcs.
1pc.
1pc.
A
J K
B
C
D
E
F
G
H
O
I
L
M
N
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
3of7
P
November2011
Page 4
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFLU2822K
For Style TFLU2822K
STEP 1 Assemble Rods-
A. Determine the Rods (F/G) to be assembled according to
your hanging height.
B. Pass Supply Wires and Ground Wire through the 12” Rod
(G), the Cross Part (O) and the chosen Rods (F/G).
C. Thread one end of the 12" RodS (G) onto the nipple on the
top of the SocketAssembly (P). Hand tighten until snug.
D. Place the Cross Part (O) onto the top ends of 12” Rods
(G). Thread the chosen Rods (F/G) into the top ends of the
12” Rods (G) as shown. Hand tighten until snug.
Figure 1
6” Rod
6” Rod
12” Rod
12” Rod
Cross Part
12” Rod
Supply Wire and
Ground Wire
Socket
Assembly
STEP 2 Disassemble Ceiling Canopy-
A. Disassemble every single parts pre-assemled on the
Ceiling Canopy as shown in the illustration.
Figure 2
Hex Nut
Lock Washer
Ceiling
Canopy
Swivel
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of7
November2011
Page 5
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFLU2822K
For Style TFLU2822K
STEP 3 Assemble Ceiling Canopy-
A. Pass the Supply Wires and Ground Wires through Swivels
, the Ceiling Canopy, Lock Washers and Hex Nuts.
B. Screw the Swivels into the top end of the Upper Rod.
Please be sure the directions of two Swivels are the same
before hand tighten until snug. This allows the lamp to
adjust angles after assembly. (Refer to Figure 3)
C. Pass the Ceiling Canopy and Big Lock Washers over the
top end of the Swivels. Secure by threading Hex Nuts onto
Swivels. Tighten until snug.
Front View Side View
Rotate
90 Degree
Figure 3
STEP 4 - Attach Mounting Screws, Small Lock
Washers and Small Hex Nuts to
Crossbar
Figure 4
Hex Nut
Lock Washer
Ceiling
Canopy
Swivel
Supply Wire and
Ground Wire
Upper Rod
Figure 5
Crossbar
Mounting Screw
A. Line up a set of holes on the Crossbar (A) and Holes on
the Ceiling Canopy (I).
B. Thread Mounting Screws (B) into the holes on the
Crossbar (A), pass Small Lock Washers (C) and thread
Small Hex Nut (D) onto the Mounting Screws (B). Hand
tighten until snug.
STEP 5 - Attach Crossbar to Outlet Box
A. Attach the Crossbar (A) to Outlet Box and secure by
threading Outlet Box Screws (not supplied) into the
Mounting Holes on the Outlet Box. Tighten until snug.
Lock Washer
Ceiling
Canopy
Figure 6
Mounting
Hole
Small
Small
Hex Nut
Outlet
Box
Crossbar
Outlet Box
Screw
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
5of7
November2011
Page 6
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFLU2822K
For Style TFLU2822K
STEP 6 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply White wire from fixture
Figure 8
Black wire from supply
(or Red)
Ground wire from supply Ground wire from fixture
Black wire from fixture
Figure 7
STEP 7 - Attach Ceiling Canopy to Mounting
Screw
A. Place the Ceiling Canopy (I) over the Mounting Screws
(B) and secure with Mounting Balls (E). Hand tighten
until snug.
Ceiling Canopy
Figure 9
Mounting Screw
Mounting
Ball
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
6of7
November2011
Page 7
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFLU2822K
For Style TFLU2822K
STEP 8 Attach Shade to Shade Holder-
a. Attach the Shade (L), Rubber Washer (K) and Flat
Washer (J) to the Shade Holder (H) and secure with
Knurled Nut (M). Hand tighten until snug.
Knurled Nut
Flat Washer
Rubber Washer
Shade
Screw
STEP 9 Attach Shade to Socket Assembly-
A. Lift the Shade (L) with Shade Holder (R) upward and pass
the Bolts on the Shade Holder (R) through the holes on the
Bar of the SocketAssembly (P). Secure by threading Screw
(N) onto the Bolts. Hand tighten until snug.
STEP 10 Install Bulb-
A. This fixture uses standard bulb with a standard screw base.
Maximum 100 watts.
B. Insert bulb and screw properly into place.
Figure 11
Bar
Shade
Lock Hole
Socket
Assembly
Shade Holder
Figure 10
Screw
Figure 12
Your lamp island fixture is now assembled and ready to use.
Enjoy!
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
or visit us on-line at www.quoizel.com
7of7
Bulb
Socket
November2011
Loading...