Quoizel TFAV156VB User Manual
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
. .
, .
INSTRUCTION SHEET IS TFAV156STYLE NUMBER TFAV156VB:
PACKAGE CONTENTS
Part
A
B
C
D
E
F
G
H
I
J
K
L
M
N
Crossbar
Green Ground Screw
Mounting Screw
Lock Washer
Hex Nut (for Mounting Screw)
Mounting Ball
6 Rod"
12” Rod with Nipple
12 Rod"
Ceiling Canopy
Socket Assembly
Shade 1pc
Steel Washer
Socket Collar
Description
Quantity
1pc
1pc
2pcs
2pcs
2pcs
2pcs
2pcs
1pc
1pc
1pc
1pc
1pc
1pc
ISSUED 12-2008 Revised 2009-06-09
J
A
B
C
K
D
E
F
G
H
I
L
M
N
!
WARNINGS AND CAUTIONS
WARNING :
Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by
●
switching off the circuit breaker or removing the fuse.
CAUTION :
These instructions are provided for your safety. It is very important that they are read completely
●
before the installation of your fixture. We strongly recommend that a professional electrician install the
fixture.
Disconnect fixture from the power source before replacing the bulb(s), making sure the bulb(s) had
●
sufficient time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may
result.
PREPARATION
●
Before beginning installation of product, make sure all parts are present. Compare parts with package
and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate
the product. Contact customer service for replacement part.
●
Estimated Assembly Time : 20 30 minutes
●
Tools Required for Assembly (not included) : Flathead Screwdriver Phillips Screwdriver, Pliers,
Electrical Tape, Wire Cutters, Safety Glasses &1,100 Watt, Type A Medium Base Bulb.
●
Helpful Tools (not included) : Wire Strippers.
,
-
1 OF 3
INSTALLATION INSTRUCTIONS
STEP 1:
a. Determine the Rods to be assembled according to your
desired hanging height.
b. Pass the Supply Wires with Ground Wire through the
chosen Rods and then thread the Rods and Socket
Assembly together as shown. Tighten until snug.
STYLE NUMBER TFAV156VB:
6” Rod
6” Rod
12” Rod
with Nipple
12” Rod
Supply Wires with
Ground Wire
STEP 2:
.
a Pass the Supply Wires with Ground Wire through the
Swivel and Ceiling Canopy.
. "
b Thread the Swivel onto the top end of the 6 Rod and hand
tighten until snug.
STEP 3:
a Screw the Mounting Screws into the Crossbar place the
. ,
Lock Washers over the Mounting Screws and thread the
Hex Nuts onto the Mounting Screws as shown Secure
the position of the Mounting Screws by tightening the Hex
Nuts against the Crossbar
b Secure the Crossbar to the Outlet Box with Outlet Box
.
Screws
.
.
.
Socket Assembly
Ceiling Canopy
Swivel
Supply Wire with
Ground Wire
6 Rod"
Mounting Screw
Crossbar
Hex Nut
Lock Washer
2 OF 3
Outlet Box
Outlet Box Screw
Loading...