6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
,.
Assembly Instruction Sheet #IS-TFAS1714VA
For Style TFAS1714VA
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wire cutters, wire
strippers,electricaltape,safety glasses.
BulbRecommended: (2) MediumBaseBulbs100W Maximum
EstimatedAssemblyTime: 20-30minutes
Preparation:Identifyandinspect all partsbeforebeginninginstallation. Check package
contentlistanddiagrams below tobesureall parts arepresent.Ifany parts aremissing
ordamaged,donot attempt toassemble,install,or operate thefixture.Contactcustomer
serviceforreplacementparts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
G
Package Contents
A
Part
A Crossbar
B
C
D
E
F
G
H
I
J
K
L
M
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Socket Assembly
Nipple 4 1/8”L with Hex Nut
Spacer Tube 3/4”D x 3 7/8”L
Check Ring
Knurled Nut
Shade
Finial
Flat Washer
Quantity
1pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
B
C
D
E
F
K
H
I
J
L
M
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of6
April2013
TFAS1714VA
FINISH: VALIANT BRONZE
R
13Ga
QUOIZEL
GND
2.4mm
1
14” Sq.
5.5" Sq.
2
12”
(2)100W Medium
Base Bulbs
(Not Supplied)
6.5”
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
PART NUMBER
NO.
1
2
G3575SH
8750KIT
REPLACEMENT PART DESCRIPTION
KIT REPLACE
VALIANT BRONZE
TIFFANY SHADE 14"SQ
2of6
REQ.
1
1
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFAS1714VA
For Style TFAS1714VA
STEP 1 Attach Mounting Screws, Lock
-
Washers and Hex Nuts to Crossbar
A. Line up a set of holes on the Crossbar (A) and Holes on
the Ceiling Canopy.
B. Thread Mounting Screws (B) into the holes on the
Crossbar (A), pass Lock Washers (C) and thread Hex Nut
(D) onto the Mounting Screws (B). Hand tighten until
snug.
STEP 2 Attach Crossbar to Outlet Box-
A. Attach the Crossbar (A) to Outlet Box and secure by
threading Outlet Box Screws (not supplied) into the
Mounting Holes on the Outlet Box. Tighten until snug.
Mounting Screw
Lock Washer
Ceiling
Canopy
Mounting
Hole
Crossbar
Hex Nut
Figure 1
Outlet
Box
Crossbar
Outlet Box
Screw
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
3of6
Figure 2
April2013
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFAS1714VA
For Style TFAS1714VA
STEP 3 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply White wire from fixture
Figure 3
Black wire from supply
(or Red)
Ground wire from supply Ground wire from fixture
Black wire from fixture
Figure 4
STEP 4 - Attach Ceiling Canopy to Mounting
Screw
A. Place the Ceiling Canopy over the Mounting Screws (B)
and secure with Mounting Balls (E). Hand tighten until
snug.
Mounting Screw
Ceiling Canopy
Figure 5
Mounting Ball
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of6
April2013
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFAS1714VA
For Style TFAS1714VA
STEP 5 Assemble the Nipple with Hex Nut-
A. Thread the Hex Nut end of the Nipple (G) into the Hex
Coupling underside of the Socket Assembly (F). By
using pliers, thread the Hex Nut against the Hex
Coupling and hand tighten until snug.
Socket
Assembly
STEP 6 Assemble the Spacer Tube-
A. Pass the Spacer Tube (H) and the Check Ring
(I) over the end of the Nipple (G). Secure them with the
Knurled Nut (J) and hand tighten until snug.
37/8”L
STEP 7 Assemble the Shade-
Hex Coupling
Nipple 4 1/8”L with
Hex Nut
Figure 6
Figure 7
Nipple 4 1/8”L with
Hex Nut
Spacer 3 7/8”L Tube
Check Ring
Knurled Nut
Figure 8
A. Pass the Flat Washer (M) and Shade (K) over the end of
the Nipple (G) and secure them with the Finial (L). Hand
tighten until snug.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
or visit us on-line at www.quoizel.com
5of6
Nipple
Flat Washer
Shade
Finial
April2013
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-TFAS1714VA
For Style TFAS1714VA
STEP 8 - Install Bulb
A. This fixture uses standard bulb with medium screw base.
Maximum 100 watts.
B. Insert bulb and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Socket
Figure 9
Bulb
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
6of6
April2013
Loading...