Quoizel TF878CVB User Manual
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
INSTRUCTION SHEET IS TF878CSTYLE NUMBER TF878CVB:
PACKAGE CONTENTS
Part
A
B
C
D
E
F
G
H
I
J
K
L
Crossbar
Green Ground Screw
Hex Nut
Nipple
Lock Washer
Canopy Chain Loop
Canopy Lock Ring
Fixture Chain
Ceiling Canopy
Shade
Fixture Loop
Socket Assembly
Description
Quantity
1pc
1pc
2pcs
1pc
2pcs
1pc
1pc
1pc
1pc
1pc
1pc
1pc
ISSUED 03-2010
A
B
C
D
E
F
G
H
I
J
K
L
!
WARNINGS AND CAUTIONS
WARNING:
● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by
switching off the circuit breaker or removing the fuse.
CAUTIONS:
● These instructions are provided for your safety. It is very important that they are read completely before
the installation of your fixture. We strongly recommend that a professional electrician install the fixture.
● Disconnect fixture from the power source before replacing the bulb(s), making sure the bulb(s) had
sufficient time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may
result.
PREPARATION
● Before beginning installation of product, make sure all parts are present. Compare parts with package
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement part.
● Estimated Assembly Time: 30 45 minutes
● Tools Required for Assembly (not included): Flathead screwdriver Phillips screwdriver, Pliers,
Electrical tape, Wire cutters, Safety glasses & (3) 100W A19 medium base bulbs.
● Helpful Tools (not included): Wire strippers.
,
1OF3
INSTALLATION INSTRUCTIONS
STEP 1:
.
a Place the nipple end of the Socket Assembly through the
hole on the top center of the Shade. Secure by threading
the Fixture Loop onto the nipple. Hand-tighten until snug.
STYLE NUMBER TF878CVB:
Fixture Loop
Shade
Socket Assembly
STEP 2:
a Secure the Crossbar onto the Outlet Box with Outlet Box
.
Screws Tighten until snug
..
Outlet Box
Crossbar
Outlet Box
Screw
STEP 3:
Pliers is required on this step
*.
a Thread one Hex Nut onto top end of the Nipple
..
b Place one Lock Washer over the top end of the Nipple
.
and then thread the Nipple into the center lock hole of
the Crossbar
c Using pliers thread the Hex Nut against the crossbar
.,
and hand tighten until snug
d Thread another Hex Nut onto the bottom end of the
.
Nipple
.
.
.
Crossbar
Lock Washer
Hex Nut
Nipple
2OF3
Hex Nut
Loading...