Quoizel RO8411AC User Manual
ASSEMBLY/ INSTALLATION INSTRUCTIONS
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
UNIVERSAL
CROSSBAR
OUTLET BOX
(2) MOUNTING SCREWS
FIXTURE SUPPLY WIRE
and GROUND WIRE
DOOR
BOLT
()2 MOUNTING BALLS
(2) OUTLET
BOX SCREWS
(not supplied)
BACKPLATE
GLASS PANEL
CAGE
SOCKET
Note If you find any Tabs do not engage Glass Panels well during assembly please
: ,
push the Tabs until they are attaching onto the Glass Panels
1. Before beginning the installation, carefully unpack and identify all parts referring to
.
,
illustration.
. .
2 Turn the electrical power to installation point OFF at circuit breaker
3 Open the DOOR and install the correct bulbs referring to the fixture markings
.
and or labels for maximum wattage Proceed to close the DOOR by placing the
/.
BOLT onto the BOLT HOLDER
.
4. Place the CROSSBAR on the BACKPLATE and align the holes in the BACKPLATE with a
set of threaded holes in the CROSSBAR. Install the (2) MOUNTING SCREWS in the
aligned threaded holes on the CROSSBAR. Next, mount the CROSSBAR to the outlet
box with (2)OUTLET BOX SCREWS (not provided).
5. :
Make the connections
Use wire connectors(not supplied) connect the HOUSE GROUND to the FIXTURE
GROUND WIRE attach the HOUSE WHITE WIRE to FIXTURE WHITE (or RIBBED
;
SIDE) SUPPLY WIRE; connect the HOUSE BLACK(or RED) WIRE to the FIXTURE
BLACK(or SMOOTH SIDE) WIRE. Wrap each connection with approved electrical
tape.
6. Carefully tuck all wires into the WALL MOUNTED OUTLET BOX and position the fixture
over the outlet box. Align the HOLES in the BACKPLATE with the 2 MOUNTING
()
SCREWS attached to the UNIVERSAL CROSSBAR. Pass the fixture over the
() ()
2 MOUNTING SCREWS and secure against by threading 2 MOUNTING BALLS
onto end of screw. Tighten until snug.
7.Refer to Page 2 for fixture caulking installations.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
TAB
BOLT HOLDER
8. Restore power to the installation point ON. Retain this sheet for future reference.
Revised 2008 03 22
IS-RO8411
Page1of2
--
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
FIGURE1
EXTERIOR GRADE
CAULK
WALL SURFACE MOUNTED OUTDOOR FIXTURE
CAULKING INSTRUCTIONS
1 Refer to FIGURE2 For assemble the MOUNTING BALLS please note that you are required to apply a
.( ) ,
small amount of Silicone sealer to the threaded side of the MOUNTING BALLS and then install them
onto the MOUNTING SCREWS
.)
2 (Refer to FIGURE1 With the OUTDOOR FIXTURE properly installed in accordance with supplied
.
Assembly/installation instructions, proceed with caulking instructions below.
Note: Be sure EXTERIOR WALL SURFACE and FIXTURE BACKPLATE are free to dirt to caulking. Using
EXTERIOR GRADE CAULK, start on one side of FIXTURE BACKPLATE and follow contour, were the
FIXTURE BACKPLATE meets the EXTERIOR WALL SURFACE upward. Proceed to caulk over top of
backplate and down other side. to ensure proper
DO NOT CAULK BOTTOM OF FIXTURE BACKPLATE
moisture drainage.
FIGURE2
OUTDOOR
FIXTURE BACKPLATE
EXTERIOR WALL SURFACE
EXTERIOR GRADE
CAULK
MOUNTING BALL
IS RO8411
-
Revised 2008 03 22
Page2of2
--
Loading...